Jeep Wrangler Forum banner

What did you do to your JK today?

13M views 105K replies 9K participants last post by  67X 
#1 · (Edited)
Every other section has this stickied so I thought I would start one. Forgive me if its in there already but I could not find it.
Anyway here's what I did.
After removing the different cover for a routine fluid change I decided to paint the cover, it needed a little touching up so I thought I would go ahead and paint it red. I already had some farm equipment paint on hand, I'm pretty sure it will hold up to any temps that might be reached.

Cleaned
Auto part



Painted
Pink Red Magenta



Installed
Bumper Motor vehicle Vehicle Automotive exterior Auto part




Land vehicle Vehicle Car Tire Automotive tire
 
See less See more
4
#21,703 ·
Pics to come

Added:
SRC Side Armor
Terra Flex Leveling Kit
Infinity Basslink
Rugged Ridge Front Seat covers
SRC Front Bumper (should be here today)

I had a '97 Land Rover, Jeeps are much more fun and more stuff available.

My name is Ellbee and I think I might be a Jeep addict now.:dance:
 
#21,705 ·
Did synergy tie rod, drag link, ball joints, rk track bar, painted bead lock rings, worked on rear bumper and started building spare axles....did HD control arm mounts, shock relocation brackets, sleeves, gussetts, got lockers ready with gears and ten factory axles and rcv front.

Decided to paint my beadlocks and forgot what a PIA the bolts are undoing and redoing.....lol:doh:



 
#21,707 ·
not bad. the directions kinda suck, they're only pictures. anyone who needs help just pm me, or you can watch the install video on YouTube. all you need is a utility knife, 13 mm socket, and a Phillips screwdriver. let it sit in the sun for an hour while I took the hard top off, and it was like 85 today in western PA.
I really like the look of the back, otherwise I probably would have went with the bestop supertop.
Windows zipped up without any problems then? That's my main concern with the amount of rain forecasted here
 
#21,708 ·
did synergy tie rod, drag link, ball joints, rk track bar, painted bead lock rings, worked on rear bumper and started building spare axles....did hd control arm mounts, shock relocation brackets, sleeves, gussetts, got lockers ready with gears and ten factory axles and rcv front.

Decided to paint my beadlocks and forgot what a pia the bolts are undoing and redoing.....lol:doh:
looks great!!!!
 
#21,714 ·
In the middle of rotating the tires. Using the opportunity while its in the air to loosen the LCA bolts so I can install the synergy bolt upgrades.

After that ill do the trackbar bolt upgrade.
 
#21,715 ·
one more piece of the military theme puzzle... getting there one decal at a time! lol I struggled with the placement of this one. To the left of the fuel cap looked stupid, and below the fuel cap I worry about spillage, and above as you can see goes up under the top a bit! Looks good when the top is down though!

 
#21,717 ·
Did synergy tie rod, drag link, ball joints, rk track bar, painted bead lock rings, worked on rear bumper and started building spare axles....did HD control arm mounts, shock relocation brackets, sleeves, gussetts, got lockers ready with gears and ten factory axles and rcv front.

Decided to paint my beadlocks and forgot what a PIA the bolts are undoing and redoing.....lol:doh:




THAT is a fkn nice ride.
 
#21,720 ·
Ran door less for the first time!! Yes
 
Top