I tried searching for a write-up on how to install lights and brackets on my windshield of my 2010 JKU, but found nothing. If anyone had a detailed set of instructions or know where to find a write up I would greatly appreciate it. I want to know how much is involved before I buy a set and try installing them myself. Thanks.
The physical installation is 15 minutes no matter who makesem and they only go on one way, LEFT/RIGHT -the windshield bkts are self explanatory and the wiring instructions will come with the mfg package-ie KC/PIAA/HELLA/Polaris/RookRiders/RudggedRidge--
You have to undo the torx screws on the bottom corners of the windshield, I used a Allen wrench. Some people cut a piece of rubber to use as a gasket to prevent scratching, I did not. Then hang back up with the torx screws you took out.
Location: From Arkansas, stationed in Colorado Springs
by far the easiest thing to do....the only part you have to think about and figure out how YOU want to do it is run the wiring harness...from start to finish, light brackets, lights, and harness, no more than an hour or two.
2010 Rescue Green 2 door Mountain Edition
IPF windshield/bumper mount lights
Smittybilt XRC 10 winch and plate
Rancho RockGear oil pan skid
Rugged Ridge Evap skid plate
TF leveling kit