Originally Posted by 30-284
Welcom to the forum, glad to see another O.C. jeep
Let me know if that doesn't help then we can look at the wiring schematic in the FSM and you can go from there.
Donn (Knotts Berry Farm here)
I have a early 1997 and bought the Mopar Hartop wiring kit for a 1997-2000. I installed everything OK until the last 2 wires. One is a Lt. blue/white and the other is a Dk. blue/Lt. green wire. The directions say to locate RH (passenger side) 10-way I/P. I took out the glove box and can not locate this 10-way?
Step #41 in the instructions said to remove the RH (passenger side)10-way I/P cluster. Where is this?
Step #42 said to remove 3" of tape from the connector.
Step #43 said to insert Lt. blue/white into cavity #3 of the connector and Dk. blue/Lt. green into cavity #4.
There is also a special note for 1997 Models
On '97 models, replace these 2 terminals with the loose terminals (item 13) supplied in the kit. Solder these connections!
I have the 2 loose terminals.
Where is the right hand side 10-way cluster located?
What do the 2 wires connect to?