Jeep Wrangler Forum banner

Durango gear box swap on 04

719 views 5 replies 2 participants last post by  SOM15Rubi-U 
#1 ·
I just did the swap with a rebuilt box from Redhead. I reused the lower intermediate shaft from the 04. I did have to slid it in to shorten it, I am questioning the angle now of the lower joint. Has anyone done this and used the stock shaft or did you use the 2000 and older shaft?
 
#3 ·
I did it and used the stock shaft, just had to tap it with hammer and shorten it.
 
#5 ·
Here is the angle on mine. About 45 degrees i would say?
 

Attachments

#6 · (Edited)
Not sure why it double posted. ..
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top