Jeep Wrangler Forum banner

Factory fog light switch use for LED bar?

8K views 11 replies 3 participants last post by  Water Dog 
#1 ·
I just replace my factory fog lights with a inch LED bar and two hood mounted LED spot lights. Can I use the factory fog light switch or is it not powerful enough?
 
#7 ·
#8 · (Edited)
I am about to do this. I figure I will just tap into the existing fog light wiring and am hoping all will be good. Here are the exact items that will go on the circuit :

Amazon.com: SHANREN 20" 126w 12600lm CREE LED Light Bar Flood/Spot COMBO Beam Off Road UTV: Automotive

http://www.amazon.com/Nilight-Off-r...im_auto_2?ie=UTF8&refRID=16W7Q94P1RD56GV41Q02

Any last thought or concerns are appreciated before I dive in!
The light bar is already a little over the stock fogs (by about 16 watts...1.5 amps), but if you plan on adding the other two to the same circuit, you definitely need to run a new fused circuit from the battery and a relay, then just use your existing fog light circuit to trigger the relay.
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top