help vibration issues - Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum

Join Wrangler Forum Today

Thread Tools

Please support our sponsors and let them know you heard about them on
Old 03-02-2012, 11:39 PM
Thread Starter

WF Supporting Member
scoobyjeep's Avatar
Join Date: Jul 2011
Location: wilsonville
Posts: 639
scoobyjeep is on a distinguished road
Question help vibration issues

i just had a 4.5 inch lift with all 8 adjustable CA's installed on my jeep, and i get some very low speed vibrations when turning i had this before the lift so i;m not sure if it is pinion angle or axle issues, also my front caster is at +2.8 and it wanders all over the place i know that with lifting comes some wandering but i think this might be a little too much

any thoughts the rear dana 35 has 150k on it possible it could be going out and causing the turning vibration but i'm not sure
"People sleep peacefully in their beds at night only because rough men stand ready to do violence on their behalf."
-- George Orwell
"those who can do, those who can't try harder"
scoobyjeep is offline   Quote
Old 03-02-2012, 11:52 PM   #2
Ricterslick's Avatar
Join Date: Jan 2012
Location: Denver
Posts: 55
Ricterslick is on a distinguished road
Front caster should be 5-7 degrees with that amount of lift.
If you have a SYE your rear pinon should be tilted just above aligned with the drive shaft so when you put hard torque in it is pulling into aligned instead of out of aligned.
Ricterslick is offline   Quote

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
kc slimlite help?? TJ Green Communications and Electronics 2 03-09-2012 10:44 AM
Vibration at Idle still not fixed jibber YJ Tech Forum 7 03-03-2012 03:14 PM
tires and gearing! help! cakes567 YJ Tech Forum 6 03-03-2012 01:59 PM
Bolt sizes and a little help fourty4magjr TJ General Discussion Forum 3 03-03-2012 11:26 AM
Painting help zstrange45 General Jeep Discussion 1 03-02-2012 11:03 PM

All times are GMT -5. The time now is 08:53 AM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC
« Back

Enter your email address:

Delivered by FeedBurner