MML help - Page 2 - Jeep Wrangler Forum
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum

Join Wrangler Forum Today


Reply
 
Thread Tools

Please support our sponsors and let them know you heard about them on WranglerForum.com
Old 03-13-2013, 12:41 PM   #31
Jeeper
 
IslandTJ's Avatar
 
Join Date: Mar 2008
Location: where I wheel: N 45║ 36.663' W 123║ 20.935'
Posts: 2,655
If you must drive your Jeep, I would keep an eye on your pinion seal on your diff for oil weeping. If you do see oil, I'd recommend resolving the vibe ASAP.

__________________
1998 TJ Moss Green Sahara w/ numerous scratches & dents whose playground is on a tropical island that's 33 miles long and 4-12 miles wide, in year-round 82 degree weather

Edit: "Now jeepin in Oregon"
IslandTJ is offline   Quote Quick Reply
Old 03-13-2013, 12:43 PM   #32
Jeeper
 
Patrick H's Avatar
 
Join Date: Nov 2011
Location: Northern NM
Posts: 3,135
Quote:
Originally Posted by WVU Mountainman
Also I did not install a rear trackbar relocation bracket. Will this affect driveline angles
No

Patrick H is offline   Quote Quick Reply
Old 03-13-2013, 12:44 PM   #33
Jeeper
 
Patrick H's Avatar
 
Join Date: Nov 2011
Location: Northern NM
Posts: 3,135
Quote:
Originally Posted by WVU Mountainman
Will adding weight to the rear affect driveline angles?
Yes.
Patrick H is offline   Quote Quick Reply
Old 03-13-2013, 12:51 PM   #34
Jeeper
 
WVU Mountainman's Avatar
 
Join Date: Jun 2012
Posts: 837
Thanks guys. I put off the springs for a long time because I was worried about this issue. Now I'm living it. I have MML ordered and will try this once I get it. Ill add weight to the back until vibes go away until I can fix correclty
WVU Mountainman is offline   Quote Quick Reply
Old 03-13-2013, 01:46 PM   #35
Jeeper
 
WVU Mountainman's Avatar
 
Join Date: Jun 2012
Posts: 837
So my only options are as follows correct....

DC driveshaft with sye
MML with TC drop
Adjustable upper rear CA's

Any other options? How far can you drop the TC skid without causing issues?
WVU Mountainman is offline   Quote Quick Reply
Old 03-13-2013, 02:34 PM   #36
Jeeper
 
Patrick H's Avatar
 
Join Date: Nov 2011
Location: Northern NM
Posts: 3,135
The best way is SYE, DC shaft, adjustable rear uppers, and angled track bar bracket.
If I were in your position and wasn't ready for a SYE (and I am/ was) I'd install the MML and measure again and go from there. I understand that a MML doesn't require a body lift, but you might want to verify.
Patrick H is offline   Quote Quick Reply
Old 03-13-2013, 02:41 PM   #37
Jeeper
 
WVU Mountainman's Avatar
 
Join Date: Jun 2012
Posts: 837
Pretty sure I was measuring wrong. I put my phone on the slanted bottom piece of the differential. I realized this slants at different angles. I put my phone on the uj pint pushed up against the differential and got a much better reading. Only off by 3 degrees now
WVU Mountainman is offline   Quote Quick Reply
Old 03-14-2013, 12:24 PM   #38
Jeeper
 
WVU Mountainman's Avatar
 
Join Date: Jun 2012
Posts: 837
I'm still confused, someone please explain how a 1" motor mount lit will not work the same as 1"spring spacers in the front. Won't the motor raise an inch with the spring spacers what am I missing? I'm not being stubborn I just don't understand?
WVU Mountainman is offline   Quote Quick Reply
Old 03-14-2013, 12:53 PM   #39
Jeeper
 
wwch99tj's Avatar
 
Join Date: Mar 2011
Location: Felton Delaware
Posts: 4,766
No

A 1" coil spacer will push the suspension further away from the frame.

A mml will lift the engine up 1" (at the fan) up out of the frame.
wwch99tj is offline   Quote Quick Reply
Old 03-14-2013, 01:00 PM   #40
Jeeper
 
WVU Mountainman's Avatar
 
Join Date: Jun 2012
Posts: 837
Got it now. Thank you
WVU Mountainman is offline   Quote Quick Reply
Old 03-25-2013, 08:47 PM   #41
Jeeper
 
WVU Mountainman's Avatar
 
Join Date: Jun 2012
Posts: 837
Brown dog MML installed. Driveline vibes are gone! Going to remove my TC skid drop tomorrow and see what happens.

Not too difficult to install but still took 4 hours to complete. Gotta notch the fan shroud and reinstall my puke jug in the AM.

WVU Mountainman is offline   Quote Quick Reply
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off




» Featured Product

All times are GMT -5. The time now is 02:16 PM.



Jeep«, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC