I was looking at KC Apollo lights... as the possible fog lights i'd like to get.
It says to "Attach a slide-on terminal to the remaining piece of wire and connect it to the switch tab marked SUPPLY( remaining tab). Route the other end to a 12 volt power source. This may be your fuse block, battery or other junction box. Before connecting to power source, install the in-line fuse carrier and fuse as shown in diagram C. If you use the fuse block, attach a slide-on terminal and either slip it on an open accessory lug or use the enclosed ATO fuse clip (see diagram C) and attach to existing fuse."
Does that mean i can just connect into where the battery comes into the fuse block? That was where my previous lights were hooked up into?