Sorry but it was years ago and I don't recall. I had it done in a 4Wheel Parts shop when I worked for their parent company so I didn't pay list price for the labor anyway. It might have cost me $75 IIRC which is probably half of what it would have cost a regular customer.
__________________ Offroad until Sunday! When you have a choice, buy American.
I just talked to my cousin and I will start collecting my needed parts and supplies so when I am ready for my next oil change we can do this. We will start early on a Saturday in case we need to roll into a Sunday. I am going to start spraying exhaust, 02S, and oil pan bolts now though.
I had the same problem with my jeep and it was coming from the same spot. The leak was the valve cover gasket and the oil pan gasket. Both were very easy to change. You could have a RMS leaking to. I'm a mechanic I did mine stages because we can only work on personal cars on Saturdays at the where I work. When I did the oil pan I change the oil pump because it was going bad.
To drop the oil pan.
1: Spray the bolts and nuts on the exhaust flange down the night before you do the work.
2: Remove the exhaust pipe.
3: disconnect the ground on the battery.
4: Remove starter.
5: Remove trans cover plate.
6: Now remove the oil pan bolts, and it will drop down out of the way. Drain the oil first.
I didn't replace the RMS it was not my leak. You will see the RMS will be a little more work to install. I had a lift and air tools ,cuts the time in half. Good luck.
Hey-I am also doing the RMS in my garage,so your not alone,just be patient,and be organized in your layout of bolts,(Cardboard Helps) To keep track of them all....Good Luck, PS-Get the ONE piece FelPro gasket!!