Jeep Wrangler Forum banner

Procedure for using 303

2K views 6 replies 4 participants last post by  Fortune 
#1 ·
I will be getting 303 Aerospace Protectant from a local boating store tomorrow.

So I've been searching the forums for the past hour to find the procedure on how to get the best results.

Here is the best i got:
"Spray on, spread around"

Do I use a brush or rag?
Do I rinse the soft top off after applying the 303?
Is 303 the only step needed? or must there be prior cleaning/wetness?

I was going to try using pledge for the windows because its available locally for cheap.

Thanks!
 
#3 ·
I use it just like I would any other wash/wax product. Hose major mud/crud off Jeep, let dry, then spray on and wipe off. I use it on the Jeep body, plastic fenders, interior, powdercoated bumpers...

Hell, I'd use it as an ingredient in pasta sauce if it wasn't so expensive. :)

For my soft top, I've got a long-armed bristle brush that I use. Spray on, scrub gently into fabric, then wipe off excess. No need to hose off afterward; you want it to stay on, as it provides UV protection.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top