Jeep Wrangler Forum banner

Removing the milk jugs

2K views 6 replies 3 participants last post by  Amw2210 
#1 ·
So today I was trying to remove the milk jugs on both my front and back bumper. I got 3 of the four off with ease, the last one is being a pain in the *** the screws are rusted and wont turn and if they do turn i think the thread is stripped and its just spinning. So for tonight I sawed the milk jug off but the plastic is still inside the bumper with three rusty screws left. Anyone have a suggestion as to how to get those out? I tried spraying it with rust killer, vice grips, drilling it out.... I got nothing
 
#6 ·
i took the jugs off the front bumper and attempted the back one. all of them had the same problem your having, instead of sawing of the jug, i sawed through the screw. i raised the screw just enough then fit the saw in and cut through. for the back jugs, couldn't figure out how to get to one of the screws so i left them on. hope this helps
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top