I just put a new clutch in my jeep. I've done several in my z and my buddy's cars. So I at least have some experience. Anyway I put flywheel on 105lbs to the crank. Then alignment tool and clutch plate and bolted pressure plate over that at 45lbs I believe it was. Then took alignment tool out and bolt trans, tc, and drive shafts up. Then I put slave cylinder in and went to check pedal pressure bc I did not drain or open hydraulic system when disassembled. I just unbolted from housing and set aside.
Anyway now I have this extremely stiff pedal pressure it will not even budge. I don't want to put anymore pressure on it bc I don't want to blow the slave cylinder. What's going on here I'm stumped? The pedal will not move towards the floor at all.