Jeep Wrangler Forum banner

wire it where?

863 views 2 replies 2 participants last post by  denisbaldwin 
#1 ·
Hi all
been looking in & under the back end of my TJ. I want to run a couple of wires 12V to the rear bumper one for a reversing LED light & the other for a rev/camera. so i have got them as far as the rear light loom grommet on the rear passenger side but was wondering where to take it from there without drilling if possible. Thank's in advance for any useful info.
 
#3 ·
Hey Joe - I'll see if I can dig up my wiring diagram that I used to wire up my tail lights (LED) and what i'm going to do for my third brake light and switched backup lights.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top