94, 2.5, 5 speed, blah blah blah. Re-doing all the brake lines and hoses...and I ran into a slight problem. I ordered the replacement rear brake hose for 90-95 wranglers, the only one quadratec had, and while it DOES have all the holes necessary where it mounts to the rear axle, the center hole in which the bolt/hose goes down to hold it onto the rear axle...is wayyyy too small, and the block at the end itself is much smaller than the stock part. This...perturbs me. I can probably use the old one again, but I don't particularly want to..anyone have any explanations for what I'm sure is a dumb mistake on my part?
Edit: Also, the connector on this new hose that connects to the steel brake lines is far too big for the stock part.