These seats are out of a Chrysler Pacifica mini van. They are 2nd row, reclineable,leather, w/ inner arm rests. Extremely comfortable, I would highly recommend them except for 1 minor detail. They are so thick and plush that they cause you to sit a little higher in the Jeep, and the end result is the seat belt is just barely long enough to fit.
'87 YJ, 4.2L built and bored, 8.5" of lift, 8.8 rear, AX15/NP 231, Tom Woods drive shafts, Flat fenders, 12,000LB winch, Custom bumpers, Rattle can paint job. Never completed...
Captain chairs, now that is comfortable. was it a pain in the ass to put those seats in? There is a section here on seat covers and some people mentioned placing seats from a Pontiac in their Jeeps. It would be nice to put some seats that will at least recline some.
I have tan and black, but went with gray and black seat covers. The tan and black ones that were out there looked to be too light and didn't look as nice. The tub is monstalined in black, so it turned out looking pretty good.
I put in 03 cavalier seats into a 90 YJ. Good comfort, proper width and height, and recline! Minor fabrication with one mounting stud if I remember correctly. As mentioned above Scrap yards are overflowing with cavaliers and sunbirds(same seats)
My seats were a direct bolt in . I didn't even have to re drill any holes. Just unbolt the seats from the adjusters and bolt on the new seats. BTW use seats from a 2 door car the seat backs will tilt forward so accessing the rear of the Jeep is easier.
95 YJ 2.5 5 speed 33" Mud Rovers SOA
A frustrating WORK IN PROGRESS