Jeep Wrangler Forum banner

2007 JKU Rubi build

1K views 6 replies 4 participants last post by  PCA4208 
#1 ·
This is me and my dad's 2007 JKU Rubicon that we recently got. Since getting it we've done a lot of things to add to the general coolness of this jeep. We've installed Grabbars metal bars in the front and rigged ridge handles in the rear. My dad got a great deal on some used weather tech floor mats for the whole jeep. Wet Okole seat covers, because they fit and look great. For some safety we put in locking hood latches and fuel door. When we got it it already had some sort of 2" or 2.5" lift and nearly new 33" tires.
Right now me and my friend are working on making some steps that are somewhat similar to N-Fab step bars. We are just adding on to the existing rubicon rails as they are easy to weld to. I'll get pictures of those in a bit, but here's the jeep.
 

Attachments

See less See more
2
#2 ·
Here's a piece of the step were working on. It's made of 2"x1/4" ERW tubing, which is just as strong as DOM when it's in small lengths as this. We basically will be modeling the steps after the N-Fab steps. The welds were done with an Arc welder but aren't the ugliest welds we've ever done. We actually considered making a kit for the steps if anyone was interested in them. Tomorrow they'll most likely be done or at least the front steps will be welded on.
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top