By the way here is how to remove the radio or get to it (someone might need this info someday)
1. remove the plastic cover right by the winshield (the one surrounding the vin#) - no screws it just pulls up (wedge a screw driver under it and pry it up carefully)
2. There are 3 screws that secure the plastic around the radio.. 2 on top that are only visible after the plastic cover by the winshield is removed and 1 inside where the smoking tray hole is (remove the smoking tray)
3. After those 3 screws are removed the front can be pryed out.. its held in place by couple of those brackets just like the cover on top that was removed in step 1
4. 2 screws hold the radio in front and 1 screw in the back. 2 big nuts hold the bracket that holds the radio from the back (anti theft)
I could not remove the 1 screw from the back of the radio so i just removed the whole bracket. The 2 big nuts are visible right in the center around the winshield air vents.
I removed the glove box just so i can get the screw from the back of the radio...
Removing the glove box... remove the 1 screw that holds the fabric that doesnt alow it to hit the passenger when opened, then pull it back almost nearly till stuff starts to fall out of it and pull towards the seat. It should pull out right off.
the stock unit is 3.5" from top to bottom but the max that should be installed is 3.25" otherwise you will have buttons hiding behind the plastic cover steps 2-3
Hopefully the one who made the hole in the right will recognize it and speak up so i can get more info on the car