Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Rear Transfer Case Seal Leaking

Join Wrangler Forum Today


Thread: Rear Transfer Case Seal Leaking Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-12-2007 10:07 PM
GoHack Take some scotch bright, or steel wool, and remove any surface rust on the portion of the drive shaft that slides into the seal.

The rust is like sand paper, and will wear away at the seal.
07-09-2007 07:58 AM
ursandal There is also a bushing in the tail cone that might be bad. I think you need to take the tail section off to replace it.

Al
07-09-2007 12:06 AM
AzTJ There are a couple of different seal designs, some larger than others and some smaller. Try going up or down a year.

And before you install another new one, take the driveshaft out, and rub a little tranny fluid on the shaft that slides into the t-case and then slide the seal over it. If its the right one it should clean the shaft and push the fluid back. Thats to make sure that the contact between the seal and shaft is right.
07-08-2007 02:18 PM
hornetfan1
Rear Transfer Case Seal Leaking

My AX-5 transmission went and I found another to put in, while everything was out I replaced the rear transfer case seal where the driveshaft connects. Put in the brand new seal and it was leaking a lot, there is a trail of oil in the driveway to where I parked. Bought another seal and replaced it again, shaft slid in perfectly, but it still leaks just as much. Is there a step I'm missing? I can't think of anything I've done wrong, and this is the last step to getting the jeep up and running. Thanks for any help.
Hornetfan1

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:37 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC