|03-18-2011 02:01 AM|
The switch itself for the turn signals is part of the harness which surrounds the steering shaft in the column. The Wiper control harness is screwed to the turn signal with a single bolt through a metal projection.
If it is still movable up and down and wipers and the brights work it sounds like it has to be the harness unplugged as stated above or the switch itself went bad which I think means you have to replace that whole harness. I haven't had to try to fix the switch before.
The other possibilities either the screw is loose or missing. The switch assembly itself is bad, or the Wiper assembly is broken in a way that only affects the connection to the metal projection that secures it to the Harness.
|03-17-2011 11:57 PM|
|drhodes||Under the steering wheel, then a plate or two, and a retaining clip then you should have access to all the wiring. If they're all in tact and plugged in there's a switch inside the column controlling the turn signals. Odds are if it feels like its not touching that the switch is gone or broken. Id start there if it's all there post a picture...good luck|
|03-17-2011 11:45 PM|
|drhodes||We replaced the entire stick in my roomates its not hard you just need a steering wheel puller and basic screwdriver and such. Took about 20 minutes.|
|03-17-2011 11:30 PM|
|topher38||i had some what of the same problem only it was the wipers that didnt work i just took the off the panal to the wire coloum under the steering wheel and my wiper plug came unplugged try doing that.|
|03-17-2011 11:06 PM|
broken turn signal
Can anyone help.. i have a 91 wrangler renegade with a broken turn signal. The wiper and brights still work but the lever just hangs there with NO blinkers! Is this an easy fix and what part do i need?