Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > 02 Jeep Wrangler... Misfires, P-0300, Reset Engine Light, Runs Fine, Repeat...

Join Wrangler Forum Today


Thread: 02 Jeep Wrangler... Misfires, P-0300, Reset Engine Light, Runs Fine, Repeat... Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-31-2011 01:01 PM
sdh796 Thanks, starting the process... replaced the coil and plugs last night... this morning all six cylinders and general misfire code...
03-31-2011 10:40 AM
TexasT I have a 99 with the coil so mine is a bit different, but if I were you I would look at all of these...
spark plugs or wires, coil pack, oxygen sensor(s), fuel injector(s), burned exhaust valve, catalytic converter, stuck/blocked EGR valve / passages, camshaft position sensor, bad ECM.
Very broad, but recommended by several sources. The thing that pops out on your post is the cracked ventilation hose...you replaced it and it worked for a few days....I would start in that area and see if there is anything else cracked or loose or old.
Good luck
03-28-2011 08:06 PM
sdh796
02 Jeep Wrangler... Misfires, P-0300, Reset Engine Light, Runs Fine, Repeat...

I have an 02 Jeep Wrangler X , 6 cylinder engine with about 75000 miles. The other day, it died on me. Looked under the hood and the crankcase ventilation hose was cracked and had fallen off... I replaced it.

It ran for a few days, then out of the blue, was driving and the engine seemed to shudder, the engine light came on, and it started to lose power and tried to die. (both at highway and low speeds) Took it to a shop, they replaced with Crank Position Sensor twice before I picked it up (they thought the replacement sensor was also bad), and I drove it home. On the way home, I had the same problem as before (shuddering, engine light, loses power).

Back to the shop, all they could figure out was that the engine was misfiring. They reset the codes, drove it about 50 miles, of course, no problems.

I pick it up today, started to drive home... same problem as before within ten miles of the shop. Drove it to an auto parts store, checked the code (P-0300), reset the engine light, and drove home...

I am assuming this will all start over again in the morning... Fearing some major mechanical issues are looming under the hood. Please help!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 02:42 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC