Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > HOWTO: Fix Ripped Soft Top

Join Wrangler Forum Today

Thread: HOWTO: Fix Ripped Soft Top Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-13-2007 01:13 AM
HOWTO: Fix Ripped Soft Top

Sooooo...back in April of '06 I was on a trip to a local ranch (my first run ever) and had to use a tree as a pivot point to make it thru one of the river beds. Needless to say, the tree scraped the top right above the B pillar on the drivers side and left a few holes that I've been too lazy to deal with.

Had the top down today and figured I would finally fix it since I finally had all the stuff and a few minutes before the game started tonite.

Dunno if it is the best way to fix the rips, but it should work fine. If it doesn't...the total cost is under $10 bux...

Here's what you'll need:
- 1 iron on patch kit (like the stuff your mom used to iron on your jeans when you were a kid):

- 1 squeeze tube of clear silicon sealant:

- 1 iron (ssshhhhhh...don't tell my wife :blush: ):

Lets get started:
1. take the top down so you can get to the affected area

2. cut the iron on patch to size so it'll cover the holes and have a good bit of overlap

3. following the instructions on the iron on patch kit, from the inside facing out, iron the patch over the holes. Use something flat on the outside so it'll mate up properly (I just put on a welding glove and ironed against it :lol: )

Once ironed, it'll look like this:

4. let it cool and then put the top back up

5. liberally apply the clear sealant to the outside of the ripped area and smooth it out

6. let it dry overnight before trimming off any excess. we'll see how it looks tomorrow B)

One last tip: use a self tapping screw in the sealant's tip to keep it from drying out:

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 03:25 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC