Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > 2012 Sunrider Soft-op issue...

Join Wrangler Forum Today


Thread: 2012 Sunrider Soft-op issue... Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-24-2013 11:36 AM
LesLazz Ok,for anyone that has the same problem as I did here's what you do...
1)Take out the window on the misaligned side
2)Loosen the stay on the same side
3)Get a guy that is 220lbs +\- and have him stand on the side, pull the bar forward (inside where it starts to bend down) and push down on the sunrider clasp bar with all his might at the same time. It WILL click in... Eventually
5)Zip window back in
6)Attach the stay again
7)Put the window lip back in
8)Leave the sunrider top closed for a couple of days and park in the sun so it stretches a little
9)Don't forget to slide the plastic sleeves back over the sunrider joint

This was done at the service department of my dealership. Worked like a charm! Just needed someone that had more muscle and wasn't afraid he was gonna break anything. According to Roger, the service guy, in a few days I should be able to open and close the sunrider with little trouble. I'm just happy it opens and closes without pliers!
05-22-2013 11:13 PM
LesLazz
Quote:
Originally Posted by PhotoWrangler View Post
When I put my top up, I first throw the whole top forward and I hook the latches to the loops on the windshield, but don't tighten them. This kind of holds it in place and keeps it from naturally wanting to fall backwards. Once that's done I kind of put one hand on the top over the sunrider latch, and then reach around the roll cage pole and simultaneously push on the top frame behind the roll cage bar, and push down on the sunrider latch.
Thanks PhotoWrangler, I did try to do something like that before I put the windows in but I think I'm going to have to start completely over (take out windows, put the top down etc) and try again. With or without the windows, it seems like something is bent on drivers side. It's incredibly hard to latch without anything attached in back. I may have to bite the bullet and drive the 2 hours to the dealership tomorrow and have them show me what's up.
05-22-2013 11:06 PM
PhotoWrangler When I put my top up, I first throw the whole top forward and I hook the latches to the loops on the windshield, but don't tighten them. This kind of holds it in place and keeps it from naturally wanting to fall backwards. Once that's done I kind of put one hand on the top over the sunrider latch, and then reach around the roll cage pole and simultaneously push on the top frame behind the roll cage bar, and push down on the sunrider latch.
05-22-2013 10:59 PM
LesLazz Ok, I have the same problem, kinda. The pin latch above the drivers side door will not go forward (or lie flat) enough to line up with the catch and when I close the sunrider top fully there is about 1 1/2" gap on the drivers side. I tried undoing the back (anchor panels?) but that doesn't seem to help. I have tugged, pushed and pulled for the last 4 hours! I just got this Jeep on Saturday and took the hardtop off relatively easily and spent all of today trying to get this to work properly. All my windows are in right and everything looks good, but I'm totally baffled and exhausted now! If anyone has any suggestions, I'm all ears ... And thumbs apparently!



Oh yeah, 2 door Sahara 2013. I even tried chasing down what I thought was a Wrangler from that distance but it turned out to be an old Land Rover and he wasn't interested in talking.
10-06-2011 08:25 AM
cavsvet74 Yep, what they said.

Latch the windshield header first. Attach the rear corners last.
Then open the sunrider.
10-06-2011 08:16 AM
oilwell1415
Quote:
Originally Posted by kjeeper10 View Post
At times I too had troubles with the passenger pin.

What I do is pull the rear corners of the back out of the body channels and lift up on the center bow. Sometimes they will latch on themselves other times I have to guide them in but it does help.

Hope this makes sense
Quote:
Originally Posted by SeaComms View Post
When going back up from the fully retracted position, I stand in the back and lift the whole top up to above the rear seats then let the front fold forward. Jump out and go to the sides and lock them in. At this point the rear is sitting completely loose. Thats on a 2010 2 door. Not sure if the 2012 is any different, but maybe somethings a little bent?
I do the same as these. Mine is also a pain to get the pins in, but not attaching the rear corners until after they are seated does the trick.
10-06-2011 07:45 AM
kjeeper10
Quote:
Originally Posted by SeaComms
When going back up from the fully retracted position, I stand in the back and lift the whole top up to above the rear seats then let the front fold forward. Jump out and go to the sides and lock them in. At this point the rear is sitting completely loose. Thats on a 2010 2 door. Not sure if the 2012 is any different, but maybe somethings a little bent?
Same, but worded differently.

Pretty much how I do it, lifting up the whole top
10-06-2011 06:16 AM
SeaComms When going back up from the fully retracted position, I stand in the back and lift the whole top up to above the rear seats then let the front fold forward. Jump out and go to the sides and lock them in. At this point the rear is sitting completely loose. Thats on a 2010 2 door. Not sure if the 2012 is any different, but maybe somethings a little bent?
10-06-2011 05:47 AM
kjeeper10 At times I too had troubles with the passenger pin.

What I do is pull the rear corners of the back out of the body channels and lift up on the center bow. Sometimes they will latch on themselves other times I have to guide them in but it does help.

Hope this makes sense
10-05-2011 10:07 PM
Mr. E I have the same issue on my '11 2 door except the drivers side is a pita. I get the passenger side locked in then sit inside and shut the sunrider completely. When the front latches pull the top tight the drivers side pin pops right in every time.
10-05-2011 05:18 PM
Celtic When you go to full down are you leaving the Sunrider sliding plastic in the full rear position?
10-05-2011 03:59 PM
Chasin Tail
Quote:
Originally Posted by Celtic View Post
Are you having the problem trying to put the top in the closed position from the full down position, the Sunrider position, or both?
Sunrider position is fine since you leave those pins alone.

I have the problem when going from full down to up, or full down to sunrider. The pin on the passenger side above the door just doesnt want to click in and lock into place.

Drivers side works fine, I dont see any way to adjust anything other than some possible tweak or secret technique that others have devised with similar issues on their tops.
10-05-2011 09:35 AM
Celtic Are you having the problem trying to put the top in the closed position from the full down position, the Sunrider position, or both?
10-05-2011 09:26 AM
sandbaja
Quote:
Originally Posted by Chasin Tail View Post
2012 Sunrider Top Issues
Since day 1 Ive had a VERY hard time getting the little pin that locks the sunrider portion of the soft-top to lock into place when Im putting the top back up. IS there some trick to it or is mine maybe bad?

Its not the latch on the front, its the pin/release thats above the door. The drivers side clicks right in and locks fine, but the one on the passanger side wont click into the lock position. The only way I can get it to lock in, is to climb into the jeep, stand on the passsanger seat facing the rear of the jeep, and really reef on the top pulling it forward HARD to get it to latch... And even then it takes 10-15 attempts for it to catch on that pin and stay locked into place.

I know this cant be right.

I dont see anything to adjust, and that latch looks like its just riveted on the door surround.

Probably something to take to the dealership to have them replace, But I thought I'd ask here first if anyone has any suggestions???
You either have something incorrect in your setup or it defective. I suspect the first. I would look at another 2012 setup (dealers lot?) or a nearby friend. Mine goes up and down without issue and the latch connects without any binding or adjustment. EDIT: read previous post..mine is a JKU
10-04-2011 11:36 PM
Djstorm100 I took mine to the dealer when I had my 11. The JKU design is much much better.
10-04-2011 10:11 PM
Chasin Tail
2012 Sunrider Soft-op issue...

2012 Sunrider Top Issues
Since day 1 Ive had a VERY hard time getting the little pin that locks the sunrider portion of the soft-top to lock into place when Im putting the top back up. IS there some trick to it or is mine maybe bad?

Its not the latch on the front, its the pin/release thats above the door. The drivers side clicks right in and locks fine, but the one on the passanger side wont click into the lock position. The only way I can get it to lock in, is to climb into the jeep, stand on the passsanger seat facing the rear of the jeep, and really reef on the top pulling it forward HARD to get it to latch... And even then it takes 10-15 attempts for it to catch on that pin and stay locked into place.

I know this cant be right.

I dont see anything to adjust, and that latch looks like its just riveted on the door surround.

Probably something to take to the dealership to have them replace, But I thought I'd ask here first if anyone has any suggestions???

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:50 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC