|12-05-2007 11:20 AM|
|TXST8tj||it may just be one of those jeep to jeep cases. the clamps on my factory hardtop fit flush over the header. so you don't have to continue taking the header off everytime you put the hardtop on and since you already have the screw holes drilled in place, while the header is off, just cut out that flat piece that goes around the clamp hole. you will end up with 3 pieces, but they will each just screw into place.|
|12-05-2007 10:40 AM|
|12-05-2007 08:08 AM|
|Walkeraviator||Sorry for the confusion.. guess i should proofread before posting... I do not have a hard top. It was a typo. However, my question has been answered. Thank you all for your help.|
|12-05-2007 07:43 AM|
|TXST8tj||i had the drill type header/bikini, hard top and soft top on my previous TJ. the drill header did NOT get in the way of either hard or soft tops. my 'new' TJ came with a no drill header and it is 111x more complicated system to use. the drill style is great b/c it's always on. you just slide the bikini through the channel and strap it down at the rollbar.|
|12-05-2007 05:15 AM|
|catoct||The drill in style header does get in the way with the hardtop, at least it did for me (maybe I installed it wrong ) You won't be able to fasten the clamps on the windshield, but you can drive around without them - temporarily, just the windnoise gets pretty high...|
|12-05-2007 03:41 AM|
|jjseel||X2. Got the soft top, and the drill in header. Yup, had to drill holes. Nope, don't have to remove for soft-top. But it doesn't get in the way of anything I can see...|
|12-05-2007 02:04 AM|
You are not clear in your post. You claim to have the hard top, but you later claim to go back to the full soft top in the winter.
I don't have a hard top, but here are my insights on the question:
Drill style header. I went this route for several reasons. 1. I'm not afraid to drill holes in my Jeep. 2. Military...move every couple of years....stuff gets lost. 3. Have to take off no-drill header to run full soft top, means storing the header also. 4. Drill style header does NOT interfere with soft top. 5. Cheaper.
These are just my reasons for doing a drill style header. As I said, I have no idea if it interferes with a hard top, but I would "guess" that it would not.
|12-04-2007 08:25 PM|
|02Prove||You have to drill holes in the windshield unless you get the "no drill header" type. To put the hard top back on you have to remove the header so the no drill type is better IMO.|
|12-04-2007 07:25 PM|
|LIL_red_JEEP||I've got the same thing. I dont remember the part number off hand. but I have the Besttop header that didnt require drilling.|
|12-04-2007 04:14 PM|
|mr4x4||they have the drilless one two|
|12-04-2007 04:03 PM|
I have a TJ with factory hard top. The bestop strapless bikini i want requires a drill in header. Now when I go back to the full soft top again next winter, how hard will it be to switch back? Does the Header screw into existing holes on the winshield frame? When i take the header off to run full top, will it leak or anything? I just want all the info I can get on the drill in headers.