|02-04-2008 10:30 PM|
|distortedtj||you buy it and we'll put'er in|
|02-04-2008 10:29 PM|
That's hitting below the belt. What you have to realize is.......The End Result!!!
|02-04-2008 10:19 PM|
i can drive mine
|02-04-2008 07:30 PM|
|02-01-2008 10:34 PM|
if you can get to it good enofe...use a dremel and cut it back to a hex then just use a smaller socket.
just a option
|02-01-2008 09:57 PM|
did the same thing on my 89 yj i have a small mig welder so i welded a new nut ontop of the bolt and spunn it out took 3 -4 try's but i got it
when you weld the nut on it warms the bolt and helps release it a little bit of WD-40 helps too
|01-06-2008 08:56 PM|
|tet1070||good luck, I had one strip out, it took pulling the motor away from the tranny to get it out.|
|01-06-2008 02:13 PM|
|payj90||you stripped the head of the bolt right, i would take a impact socket a little smaller than the bolt and beat it on there with a hammer. if you dont have impact sockets take a 6 point craftsman socket and do the same, and if it breaks take it back.|
|01-05-2008 08:21 PM|
|01-05-2008 07:37 PM|
I'm trying to get the bold off of my starter, since it just died. i got the first one off with no problem, but then i tried getting the second one off and i stripped it. does anyone have any tricks to get a stripped bolt off?