|04-17-2012 04:23 PM|
|HHSOCCER28||I'm having the same problem you had. Could you post what color wire went to what?|
|12-27-2011 10:57 PM|
|12-27-2011 10:26 PM|
If it comes to it, ill do that and just tie in but id like to figure out the root cause. I feel like i'm missing something from my fuse box.. Im missing the clock and the radio fuse, but theres only one of the two clip things on each. Tell me what your thoughts are.
I think I can Just run a wire from the "radio" point with a fusable link, I'm 99% sure its a 12 volt constant power source. and the stereo is grounded so that's all i need? Makes sense in my head lol.
|12-27-2011 09:53 PM|
|12-27-2011 09:39 PM|
|tyborbogdan||So i have everything wired up correctly, But theres no power going to the constant 12v power cable, I looked at the use box and the radio fuse seems fine, Does the clock fuse control this? Any other thoughts on which fuse it might be? I didnt notice any that were burnt out.|
|12-27-2011 07:36 PM|
www.the12volt.com Is the place I go to find any and all wiring information for stereos or alarm installs.
here is the link to your vehicle 1990-92 Jeep Wrangler Stereo Wiring Information
and here is the list of the wires in case youre too lazy to click a link lol (relax its a joke)
1990-92 Jeep Wrangler Stereo Wiring
Right Front Front Speakers4" x 6"
DashLeft Front (+)Gray Left Front (-)Yellow
Right Front (+)White/Red Right Front (-)Black/Red
Rear RoofLeft Rear (+)Gray/White Left Rear (-)Brown/White
Right Rear (+)White/Black Right Rear (-)Brown
|12-27-2011 07:30 PM|
|ratuna||Check the pink wire without keys in the ignition or lights on and see if it has power, if not check your fuse block and see if anything is burned out. Running directly to the battery would work but you would need an inline fuse. an easier option would be a "add a fuse" google it, pretty self explanitory.|
|12-27-2011 06:36 PM|
|tyborbogdan||Hey so i managed to get everything hooked up and working, my issue now is that every time the car is turned off, the stereo resets, i understand that this is caused by the constant power is not right, I bridge the constant and ignition 12 volt wires like suggested by another source, If this problem persists after checking fuses should i just run the "constant 12 volt" directly to the battery? yes/no, Im not an electrician.|
|12-26-2011 08:54 PM|
|ratuna||Here is a thread about a 91 YJ most of the colors in the diagram match yours but there are a couple of differences. http://www.wranglerforum.com/f8/1991...tic-57444.html|
|12-26-2011 08:38 PM|
Use a meter to verify but some answers should be:
Constant 12V+ Wire: Pink
Switched 12V+ Wire: Purple/White
Ground Wire: Black
Dimmer Wire: Red/Black
To find the speaker colors, check the speakers themselves and see what colors go to them.
|12-26-2011 08:16 PM|
|12-26-2011 07:11 PM|
need wiring help
The previous owner of my jeep took out the stock stereo and cut the wires, so im left with loose wires, the issue is that I dont know which wire is what, every thread ive looked at has either listed colors i dont have or didnt list ones i did, My jeep is a 92 YJ. I just need to know which wires are for what. Here is a list of the colors. The color in capital is the main, the lower case is the stripe color.
13 Brown White