|01-31-2008 09:56 AM|
I actually bought a set of 4.88's two weeks ago. The guy I got them from said to hold off on installing then until I get the 35's, so they will be sitting in the garage for a few months until I can come up with the money for them.
Thanks for the input everyone, I'll let you know how it all turns out when I finally get it put together.
|01-30-2008 08:17 PM|
i live in an area with now mountains. for me the 4.56 gears are perfect with my 35" tires and 4-spd auto tranny.
in an area with mountains i would have installed 4.88 gears.
most of the time i drive with 100 kph (62 mph) on the german "autobahn" and then in 4th gear with O/D i have exactly 2000 rpm. thatīs enough to accellerate without shifting down and low enough for a good mpg.
when i was on holiday in the alps where i had to climb hills the 4.88 would have been still to low.
|01-30-2008 07:36 PM|
If you gear too high with your 4-speed auto, like with 4.56, you'll always be pushing on the overdrive button to get it downshifted slightly for more response both around town and on the highway.
After driving his 4-speed with 35" tires and 4.88, I wish I had that exact setup... it's a great combination.
|01-30-2008 07:12 PM|
|4point||Just as a comparison I have 33" tire and 3:73 gears. So with this tire size versus these stock tire size it is roughly equivalent to having 3:54 gears.|
|01-30-2008 07:06 PM|
|01-10-2008 04:54 PM|
|4.0l sahara||Oh I thought they were used|
|01-10-2008 03:45 PM|
|01-10-2008 03:44 PM|
The bigger cost will be the labor for having the gears changed out. I'd rather pay the extra money for the 4.88's if that is the best approach. This Jeep is my daily driver so I want to make sure I do the right thing the first time.
Thanks everyone for the input!
|01-10-2008 02:36 PM|
|4.0l sahara||I heard used gears can be noisy.|
|01-10-2008 02:08 PM|
one more thing:
if you reagear, think about intalling some lockers at the same time. it īs only a bit more work and itīs worth the money.
i installed ARB lockers with m 4.56 gears.
|01-10-2008 02:05 PM|
i would suggest unlimited just get teh 4.56 for the GREAT price it will be a great gearing even if its not the best, i have a manual and 3.73's ands 35's and i think its fine, so wiht and auto adn 4.56's youll be doing great
as for 4point, if you're going to be paying the same price for 4.88's vs 4.56's(whish u will be) you might as well just go to 4.88's
but it is not worth the extra $250 ish for unlimited
|01-10-2008 01:25 PM|
|01-10-2008 01:10 PM|
i was about to say...older jeeps have the 3 speed.
if you have a 4speed and plan on 35's sometime soon then 4.88's would be great.
|01-10-2008 01:06 PM|
|Unlimited||Correction, I have a four speed auto trans.|
|01-10-2008 12:52 PM|
|nicolas-eric||i have 35s with 4.56 gears and a 4spd auto tranny. it works perfect for me.|
|01-10-2008 12:46 PM|
|mrbigjeep||i'd go 4.88 if 35's are in the future...but 4.56's wouldn't be bad if you get a good deal...there isn't a huge difference so you may as well go lower.|
|01-10-2008 12:00 PM|
|01-10-2008 11:59 AM|
|01-10-2008 11:56 AM|
|01-10-2008 11:14 AM|
|4point||Jerry, wouldn't going from 3:73/33's to 4:56/35's be a reduction? I'm not saying you shouldn't get 4:88's.|
|01-10-2008 11:07 AM|
|01-10-2008 11:03 AM|
|Jerry Bransford||For 35" tires and a manual transmission, speaking from personal experience, 4.88 is a very optimal all-around ratio. It's what I am running and I am VERY (totally!) happy with it. I am happy not to be running 4.56... which "works" ok for 35" tires but you'll find yourself downshifting a lot more for even gentle grades, plus you'll be traveling faster on offroading trails than you need to.|
|01-10-2008 10:53 AM|
|4point||Yes, that is normal and a good deal, lucky you.|
|01-10-2008 10:42 AM|
Time to Regear:
I'm currently running 33 inch tires with my stock 3.73 gearing and auto trans. This combination seems to be working fine, but I'm planning on going to 35 inch tires in the near future, so I'm looking into regearing my differentials (D30 front, D44 rear). Since I know very little on this topic, I'm hoping I can get some good advice.
A guy down the street from me has a new full set of Superior gears that he says I can have for $250. The front is 4.56 and the back is 4.55. He said that he bought them and then decided to go with 4.88's.
Is the difference in the front and rear ratios normal?
I will not go bigger than 35's, that being said, are 4.56's the best way to go?
Thanks in advance for the assistance.