Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Remove Body 1988 YJ

Join Wrangler Forum Today


Thread: Remove Body 1988 YJ Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-09-2012 09:30 AM
wherewasi Brendt,

Thanks for the feedback. The picture helps a lot as well.

One question leads to the next it seems...

When I'm done and the body is off, the front and rear tub-floors will be attached to the body, correct? It seems that way from the documents I have. Is there some kind of grid or other support under the tub-floors that they're spot-welded to? Or maybe a flange around the body as well? I'm just trying to understand what I'll be looking at in case there's gonna be a rust-fest after I remove the body.

Thanks again for your response... my education continues...
Tom
03-06-2012 06:31 PM
brentd711 It's almost that easy. I found it easiest to unbolt the fenders from the tub and lift the whole front clip off, radiator, fan shroud and all. It can be done all by yourself if you don't have back issues. Four rugged boys can lift the tub off even with the windshield, seats and rollbar still installed.

The body bolts will be a pain, it's helpful to drill small holes through the floor of the tub at each nut location and flood them with PB Blaster a few times before you try to remove them. You'll have to take the shifter off, the T-case shifter can stay. The steering shaft isn't too difficult, gas tank fill and vent lines take some finagling to get off and on, the clutch master and brake master can give you some issues when you get ready to reconnect it all and bleed them. Tag all the wires and you'll be fine.

03-06-2012 09:26 AM
wherewasi
Remove Body 1988 YJ

I'm just throwing this out for feedback. It seems like some folks have removed the entire body on their Wranglers to make it easier to combat rust and do some other stuff 'down under' (lift/new body mounts etc.). My project is going to be a bit of a 'restore', and I'm thinking of doing the same.

Are there any threads on here with good details/pics re: getting the body off? I have seen a few... It can't be as simple as taking off those 11 body mounts and lifting, can it?

Go easy on me... I have no idea what I'm talking about.

Tom

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 12:00 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC