Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Borla Header install 89 YJ 4.2L, gasket question and Idle issue

Join Wrangler Forum Today

Thread: Borla Header install 89 YJ 4.2L, gasket question and Idle issue Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-13-2012 12:03 AM
BDK Sounds like you have a vacum leak and your timing is off.
03-12-2012 07:27 AM
Borla Header install 89 YJ 4.2L, gasket question and Idle issue

Installed the Borla Header part # 17062 and a used intake manifold on my 1989 YJ 4.2L. Original Carter carb and all emissions intact. Two questions for anybody that is much better under the shade tree than I.

One: The Header came with a very thick gasket, do I need to install a second gasket for the intake which is like the factory setup?

Two: After installing the header I re-installed everything exactly as I found it, with the exception of the EGR tube which I couldn't remove from the stock header so I capped it off on both manifolds. Now when I start it the engine idles for about 2 seconds at 1k RPM and then runs up to 3k RPM for a couple seconds back down to 1k RPM and then dies. Can repeat this cycle if I hit the throttle after it returns to 1k. There is a lot of popping sounds also which further confuses me.

Any ideas? Guessing vacuum leak somewhere but this seems pretty extreme for a vacuum leak, right?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 10:20 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC