|04-04-2008 05:48 PM|
|jeeperman||If the blinkers and flashers don't work, it sounds like something is grounded that shouldn't be. (At least that was the case when I did my LED lighting all around). Check all of your wiring to make sure nothing is shorting out. This could go along with your battery issues. Good luck.|
|04-04-2008 05:34 PM|
maybe u puled the blinkers switch wires off or soemthing?
sorry cant be much help on that as my light switch is not on the steering column.
|04-04-2008 05:19 PM|
|jpdocdave||ya, just look in owners manual for fuses, relays, and flasher related to the turn signal system. start w/ the basics is my first step.|
|04-04-2008 04:33 PM|
i've checked the fuses in the glovebox for the blinkers and they look fine. By relays you are referring to the set next to the battery'?
|04-04-2008 04:14 PM|
|jpdocdave||i just read your other thread about your battery probs, and not getting jeep to start even with a jump, w/ that in mind check fuses, flashers, and relays before you dig any further. sometimes trying to jump battery, that weak can blow fuses and so on.|
|04-04-2008 02:40 PM|
Installed new mulitfunction switch and now my blinkers and hazard light dont work.
i was hoping someone ran into this issue. i just replaced the mulitfunction switch on my 01 Wrangler TJ and fog and headlights work fine...however now my blinkers and hazard light do not work...do i need another relay switch separate from the multifunction switch?
when i swapped it out it was a 1:1 plug, unless i'm missing something here.
any help is appreciated. thanks in advance!