|04-17-2008 10:36 AM|
|Triple88a||Jerry, dont you know the little resistor from ebay improves mpg by 30%? jeez hehe|
|04-17-2008 10:34 AM|
|Jerry Bransford||A chip CERTAINLY isn't going to improve fuel economy without creating other problems. What, does anyone really think it's that easy to get better fuel economy and that Jeep wouldn't have done so already if it were that easy? All the US car manufacturers are under enormous pressure to improve their fleet fuel economy averages and you can bet all the easy stuff was done long ago.|
|04-17-2008 10:18 AM|
|Triple88a||If i have it in my hands i'd put it in and see if it makes a difference in mpg.|
|04-17-2008 07:03 AM|
THANK ALOT .. I WILL TAKE YOUR ADVICE INTO ACCOUNT
|04-17-2008 07:01 AM|
|Wrangler_oman||Well Thank You Guys .. I Was Wodering To Put It Or No|
|04-17-2008 06:58 AM|
WELL I WAS OUT OF MY COUNTRY FOR A TRINING COURSE I,M BACK TO BUSINESS NOW
|04-15-2008 06:18 AM|
It's been a few years since I've run a car on a dyno. They have one at the ALL Ford's Nationals here in Carlise. I believe they charged me $30.
I'm sure you can find one in Chi-Town somewhere. Just look for performance shops on-line or in the yellow pages. You can ask any aftermarket part suppliers and I'm sure they find one for you.
If you intend to dyno your Jeep, I would suggest multiple runs (without the chip) to baseline your engine. Change the chip and pull a few more runs to get an average.
|04-14-2008 05:18 PM|
|Triple88a||I'm just curious, any one have any idea how much a dyno run costs?|
|04-14-2008 08:24 AM|
|4point||I met a guy this weekend who installed the Edge Trail Jammer on his TJ. He said on the trail there was no difference but on the road it was a very noticeable difference.|
|04-14-2008 07:22 AM|
There's many ways of learning: Making your own mistakes is the hardest way. Watching other people make them is much easier. Osmosis also works....soak up on the facts... There is no 3rd party unbiased "certified testing" for these items. Show me a dyno report from a certified testing company with build specs and I would consider the benefit. I lived in Missouri for a couple of years..you're going to have to show me the proof.
I'm not anti-technology... I've run chips and intake systems on some of my cars and have seen direct benefits in throttle response and hp gains. The chips and induction systems were proven and pre-certified on a dyno.
Some engines will simply not benefit from these devices. You need to spend a lot of money in the mechanical area to improve the 4.0L...(check the stroker motor mechanical specs)
Nothing but snake oil...
|04-11-2008 04:56 PM|
|04-11-2008 04:21 PM|
|04-11-2008 06:22 AM|
The chip is a waste of money...save it for gas.
|04-11-2008 02:44 AM|
|jbone03||Personally I would go with the Volant Cold air intake, or S&B cold air intake. They both have a box design so there's less chance of sucking in water/mud while wheeling. They both seem to have a lot of good reviews. S**Tfire plugs are just that way over priced for the about the same spark as regular plugs. Want better spark upgrade to coil pack ignition system or high voltage system then you can run larger gap on the plugs for bigger spark and better combustion.. As far as the Cats. switch to high flow. This will help keep emissions down (if you do emissions testing where you are) and help keep Check engine light from staring you in the eye. Another alternative is O 2 sensor replacement that send the ECU the proper signal so you can run no cat's and keep the check engine light off. The key thing here is if the check engine light is on the engine may be running in open-loop mode there for you wont see the performance gains promised by the chip you want to put in.|
|04-10-2008 10:33 PM|
|04-10-2008 10:00 PM|
|04-10-2008 11:34 AM|
|[TheYJGuy]||x3 K&N sucks. They have a higher airflow because the holes in the filter are so big.|
|04-10-2008 10:13 AM|
2x on Jerrys advice. I woudlnt get rid of the intake pipe though as it flows much better than the stock ribbed pipe with many many sharp bends. I'd look for a better filter with a cover over it. I'm now looking for a small factory box with paper filter from some vehicle and then use a duct leading out of the engine compartment for colder air.
The splitfires are crap. The reason why they say they are better is "because you get the 2 sparks"... such a load of crap. Electricity doesn't work like that. It looks for the shortest less resistant route to ground. Same goes for the Platinum plugs with multiple prongs. Its all snake oil. We are all happy with our champion plugs.
|04-10-2008 09:43 AM|
I hate to be so blunt but I'd get rid of the Splitfires and K&N cold air intake. Split Fire spark plugs are nothing more than a poor quality spark plug that is way overhyped (snake oil) in that it does NOT improve performance unless the plugs it replaced were completely worn out. And the K&N filter itself is going to allow that fine desert sand, dust, and silica in your area to flow right past it. The K&N air filter is notorious for letting the fine stuff past it and widely known tests of the K&N air filter that compare it to 8-10 other air filters have proven that.
Hate to be so negative but I wouldn't have either of those on my TJ.
|04-10-2008 09:28 AM|
I have installed borla back kit and headers with K&n cold air intake, split fire spark plug and I have removed the catalytic converters... Now Iím thinking of installing hypertech chip do you think that I need to but back the catalytic converters then install the computer chip or install it without it ( the check engine in appearing with me).
What is your suggestion?