|03-26-2012 06:52 AM|
So youre the guy that bought the other set! so the nuts were'nt welded in place, thats not a deal breaker, "We have a can do attitude"
Thanks for the Reply, and now I will be off to do the pay-pal thing!
|03-25-2012 08:32 PM|
|0III0forlife||I was your guinea pig!...LOL. I bought the same ones for my '87 and used them. they work well. I spot welded the nuts into the insides of the holes, and also made a set of weldable hockey pucs for my drop down trans case and welded those on too. the steel is good quality, and i believe its 3/16. or there about. I know its a guage instead of a fraction number, but its heavier than 1/8 and lighter than 1/4 hows that?...LOL.|
|03-25-2012 06:55 PM|
It's 200 for both.
|03-25-2012 03:33 PM|
I haven't used them but at $200 a side that looks kinda pricey. It might be worth it if you can weld them yourself, though.
I had a local shop burn out the old nutserts and weld 1/8" flat bar to the frame rails with nuts tacked on the back side. He also plated my rear crossmember and both rear frame rails (3 sides each) plus a couple of other little things for $425.
|03-25-2012 03:18 PM|
I can weld them in just my break is for doing lighter sheetmetal for furnace plenums and trunk lines,
the local guys are a bit more in price, still was hoping someone had used them here, that way Im not the guinea pig, like usual lol
|03-25-2012 03:11 PM|
3/16" thick or 1/4" hard to tell I have read other reviews and another benifit are the nuts are welded where they need to be
|03-25-2012 11:39 AM|
|brentd711||How thick is that steel?|
|03-25-2012 10:49 AM|
Not saying anything bad about the manufacturer-I don't know them-but after you pay for them, tax, and shipping-would it be worth going to a welding shop and see what they can do? Or are you doing this yourself? We have a large welding shop in town, they work on big rigs, whatever-not a one bay operation-but they will still bend, cut, shape, weld anything you can bring to them. They just don't do the 'install'. They have the big metal brakes to bend the heavy stock.
If you are going to install it yourself but can't fabricate it-see what a local shop can do for you.
My suggestion and 2˘ worth...
|03-25-2012 10:41 AM|
|03-24-2012 08:47 PM|
YJ Frame Repair
Has anyone tried these frame repair items I found on ebay?
I really like the one piece design, if I were to make one it would prodably have to be a three piece welded repair.
I dont have access to a metal break that could bend it sheet metal? What do you think?
eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices