Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > JK Jeep Wrangler Forum > JK General Discussion Forum > MetalCrafters Insert

Join Wrangler Forum Today


Thread: MetalCrafters Insert Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
03-31-2012 07:14 PM
marc1230 I did the same mod today - the fitment was imperfect , even after I relocated the air temp sensor, and removed the bottom clip-on hold-down from the wire assy. I think problem could be that when you screw in the mesh , attaching to the ribs at the bottom - you can slightly change the geometry of the original grill, and then it doesn't quite fit flush when you reattach. still thinking about whether it is worth it to retry or remove the mesh and start over
03-25-2012 08:15 AM
ezymount
MetalCrafters Insert

Just installed insert yesterday. Quality looks good, Fits well, looks OEM. Caution: Use caution when sliding speed nuts over plastic ribs on lower grille guards. Nuts seem to be slightly undersized, compared to thickness of plastic ribs. Requires some force to get them into position. I had to use end of screwdriver handle to tap them into place, and due to force required, partially dislocated part of one plastic rib from the back of the grille assy. Everything still went into place and resulting install is secure. Also, the air temp sensor relocation is a snap, but you have to remove the bottom clip-on hold-down from the wire assy, as it does not allow the grille assy to be pushed back into place, with the insert installed.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:27 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC