|04-07-2012 08:48 AM|
|Grateful Parrot||Thanks. But did the Kroil on the top and bottom and let it sit for a little bit, then with a very light grip vice grips, they came right out. It's a good think I live about 3 miles from the Kano Labs.|
|04-06-2012 05:51 PM|
|gmiller0737||Very Easy I have done 1000's of water pumps,Put 1 nut on a stud & run it down about 3/8" or so Now put another nut on top hold the bottom one & tighten the top one locking the 2 together then remove stud by turning by lower nut,Reinstall in new pump than remove nuts,Repeat for the other 3 studs.|
|04-06-2012 05:18 PM|
|04-06-2012 04:43 PM|
|Grateful Parrot||Thanks brother. Something blew up on my on the highway. AF was everywhere. I'm assuming water pump. I had already bought new water pump and radiator a two months ago when I had to backflush my heater core and the water looked sick. So I went ahead and bought the stuff and been meaning to put it on, but work and weather wouldn't allow it. Now I'm forced to do the replacements, and it's sunny. go figure.|
|04-06-2012 04:27 PM|
Yes, they should, & yes they are.
I would carry the old water pump with you to make sure you got the right size/length studs if you go that route though, there are a lot of different sizes believe it or not
|04-06-2012 04:16 PM|
|Grateful Parrot||thanks. will start dumping kroil on them and see if I can get them out. Would any of the big auto stores have them in stock? Are the studs still lefty loosy?|
|04-06-2012 04:14 PM|
|The Toolman||No problem, yes you will either have to extract the old studs or get new ones. Typically, if you have soaked the old ones with a penetrant spray of some sort & cannot get them out by either using vise grips, doubling two of the nuts on a stud & wrenching the stud out that way, I would recommend seeking out some new studs|
|04-06-2012 04:01 PM|
Water pump replacement help please. Pretty please.
Ok. This might be a stupid question for those who have done this a hundred times, but the replacement water pump did not come with the studs for the fan blade. Am I suppose to buy new studs or somehow take the old studs out and reuse them? TIA.