Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > Need help with Clutch Problem

Join Wrangler Forum Today

Thread: Need help with Clutch Problem Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-27-2012 03:31 PM
cozeinlb If it is Master Cylinder leaking you will likely not see the leak under the hood. Look inside on firewall and see if fluid is running down from where pedal linkage goes through the firewall.
04-27-2012 03:15 PM
kik Usually when that happens you need a new clutch due to wear. Your slave cylinder could also be allowing fluid to come through, without an external leak. The same for the Internal Control Unit. If you have to replace the clutch get a clutch kit that includes the clutch, pressure plate, bearing and control unit. You most likely need a new slave cylinder. It's a bit expensive but you might want to consider a new line from the slave to the control unit. A lot of times they'll break. When you bleed it use a pressure bleeder and do it forward and reverse and do it a few times. These systems are notorious for holding air which will cause grinding going into first or reverse.
04-26-2012 05:02 PM
RBP thanks Romulus! I 'll check it out, please bear with me if we have more conversations, I don't know much about Jeep's or hydraulic clutches but I'll get there soon with all the help flying around in the forum, nice bunch & helpful. thanks again. RBP
04-26-2012 04:08 PM
Romulus Any leaky from the clutch MC or SC (which may be hard to see... think that's an internal slave cylender model). Could require replacement of either/both.

I just replaced both on my '95 YJ (4.0, AX-15)... seemed to have a bad internal spring/seals. Was developing lots of slack in the pedal after in-city traffic driving, clutching. Eliminated the problem, replacement firmed up everything.
04-26-2012 03:53 PM
Xpress Bleed the air out of the clutch.
04-26-2012 01:58 PM
Need help with Clutch Problem

I have a 90 YJ with the 4.2 6cyl.the clutch pedal goes right to the floor to disengage & engages about 1" off the floor. shifts good up & down . can't find a way to ajust the travel. anyone have any suggestions???

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 09:17 AM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC