Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Help with Track Bar

Join Wrangler Forum Today

Thread: Help with Track Bar Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-04-2012 05:22 PM
Originally Posted by MR.CLIFFORD View Post
If that doesn't work out well ditch it and buy a Currie TJS or TJJ model.
fixed it for you.
05-04-2012 05:01 PM
rando i have the same trac bar on my jeep. i am wanting a replacement tie rod for it does any body have a part number or description to get one at a parts store.
03-05-2008 06:52 PM
Originally Posted by MR.CLIFFORD View Post
and buy a JKS.
what he said ^
03-05-2008 01:08 PM
BPD119 Joe ehat one did you go with?
03-05-2008 02:52 AM
Joe Dirt I got so sick of mine that I replaced it with a better one.
03-04-2008 08:29 PM
MR.CLIFFORD I usually put a jack under rod ends if they like to move inside the taper. Just put a little pressure on the rod end to keep it from spinning the tighten it again.

If that doesn't work out well ditch it and buy a JKS.
03-04-2008 07:24 PM
Help with Track Bar

I have the Full traction track bar. it has a screw in tie rod end with the nut and cotter pin. recently i noticed the nut was loose and it has been making a clunk noise when i turn, and hit bumps.

i took out the cotter pin and attempted to tighten the nut down, but the whole stud and nut turn, after a while i was able to finally get it somewhat tight, but this doesnt seem normal, i am not impressed with this track bar, is there an alternative one to use or is just a bad tie rod end? Also if i do get a different bar is it going to make a difference that i had to drill out the hole on the axle end for the bolt to fit with the new full traction one?

any help would be great

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 02:52 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC