|06-09-2008 05:26 PM|
i cant just compensate in my measurements? my lift is gunna be kinda expensive... im getting everything seperate based on quality of individual components. i got a lotta stuff i need before i can do 4" correctly.
the reason i wanted the sye first is so that i dont have to drive around with a 4" lift with vibes for however long i have to wait for this sye to come in.
...i know, washers for a temp tc case drop...but thats homo
|06-09-2008 05:00 PM|
|Jerry Bransford||I'd wait until all that is installed then measure for the CV driveshaft length. Personally I'd wait to buy the SYE and CV until you're off the 2" BB and have installed the 4".|
|06-09-2008 04:36 PM|
Ordering SYE/CV shaft
here's the deal:
right now i have 1.25" bl, 1"mml, and a 2"bb on 33's.
my garage has a 33 engineering belly up skid in it ready to go on.
i know i will need to install the skid to do my measuring for my shaft, but here's my question: i will be going to a 4" lift eventually, what am i supposed to do about that as far as my meausrements?
...i dont have to wait for my future lift do i? this is a daily driver by the way
also i have 8 adjustable control arms ordered from Full Circle Fab 30miles north of me that'll get made when i get the SYE(incase someone was gunna say i needed adjustable uppers for the SYE)