|05-20-2012 09:36 PM|
I describe my radio install on my blog: Jeep Wrangler Radio Install | KØNR: Radio Enthusiast
73, Bob K0NR
|05-20-2012 06:59 PM|
Documented my ham radio install in this thread...
|05-20-2012 06:37 PM|
May not be the prettiest, but I sure do like it.
What I used:
2 pieces angle iron, ~12"
3 radiator band clamps, ~76mm(3")
1 piece 1x1/8x~18" aluminum bar stock
2 small washers
1 bolt/washer, ~5/16 thread and tap to match
3 bolt/washer/lock nuts, ~5/16 thread
1 bolt/2 washers/lock nut/nylon washer, ~1/4 thread x ~1"Length
~ 20' submersible pump power cable (12ga braided water shielded 3 strand)
Found/scrounged some, bought the rest, about 50$ in so far.
tap from above
Drill / bit index
ability to bend metal
wrench/sockets/fastener head tools (torx, allen, etx)
Used the radiator band clamps to attach the 1st piece of angle iron to the "roll" bar in the upper left corner, at the A pillar. Took the second piece of angle and bent it to the angle of the windshield to maintain a level plane, ~80% or so. Removed the sun visor, and using the 2 small washers, attached the angle iron to the windshield frame with the visor bolts / holes. Bolted the two angle irons together in the corner (1 of 3 bolt/washer/lock nut). Tapped a hole towards the right of the 2nd angle iron and put a bolt in it, more for stability than support (going into the windshield frame, similar to the sun visor holes). Attached alum bar from angle 1 to angle 2 (bolt/wash/lock nut 2 & 3), mounted radio bracket to center of bar (1/4x1 bolt/lock nut) with nylon washers in between (so it can swivel). Used alum scrap to make a mic holder with the 2nd sun visor bolt hole set, ran sub pump wire to battery (with fused link) and attached it to the quick connect behind the radio, so I can take it out. As this is a FT 2900, I was able to also cable lock the radio to the angle iron as a theft deterrent/keep a radio from slamming into my face device.
It was too sunny to snap a good pic, sorry.
|05-16-2012 03:32 PM|
I can get a picture of what I am talking about if it would help you visualize it.
|05-16-2012 03:01 PM|
|05-15-2012 04:10 PM|
Here is mine. 05 TJ. Yeasu FT-8800R
|05-14-2012 10:52 PM|
|mzbrandi||Nice idea. Would like to see antenna placement on the new JKs.|
|05-14-2012 07:23 PM|
HAM radio in jeep
While considering radios for a jeep, it struck me that I could ask you guys- so lets see some pics of your HAM radio setups!