Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > General Jeep Discussion > Jeep towing problem

Join Wrangler Forum Today


Thread: Jeep towing problem Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
05-29-2012 07:33 PM
psouza
Quote:
Originally Posted by IBHIPRU View Post
Here is the sequence I follow which pretty much follows the manual (1) Ignition on ACC (2) Transmission in neutral (3) transfer case to neutral (4) transmission to park (5) emergency break off.

I am taking this quote literally. Ignition should not be on ACC. There is a position that unlocks the steering but does not energize any of the electronics. IF you are actually using ACC and IF the traction aiding crap is energized and working, and IF while towing, the front end scrubs in a turn (it will) then the brakes may be electronically applied. I tow this way but am not blessed with that Govt. mandated "stuff". I tow my '05 Rubicon this way and the front tire wear increases because of the rear overhang of the camper will cause the Jeep front end to travel in a wider arc than it would under its own power. The traction controls are sensitive enough to respond to this if they are powered up.

Phil
07-14-2011 06:22 PM
C.L. [QUOTE=IBHIPRU;405309]To answer an anticipated question someone might have, I verified the brake freeze up was not the result of a brake buddy malfunction.

How did you verify this? If something's locking up your brakes, and you have a device designed to hit the brakes remotely... The manual may also recommend pulling the battery to disable the brake booster for this very reason.
07-14-2011 06:02 PM
stimpy Just out of curiosity when your towing that Jeep does the odometer on the Jeep still show it racking up miles ?
07-14-2011 04:17 PM
hobiecat I too will be towing, a 2005 TJ behind a Class C Winnie. Can you tell me what kind of towbar and brake buddy you have and if you like them both ? Thanks
07-14-2011 04:09 PM
hobiecat I just got a Class C Winnebago and want to tow my 2005 TJ, 6 speed, 4L about 4k miles with lots of mountains. I have no setup yet and would appreciate any help and or suggestions. Reading some of the other threads it looks like I need or should have a brake buddy. Are they hard to hook up and what is a good towbar ? Thanks
07-21-2009 06:46 PM
birdhunter How about the ABS?
Could it be braking on a bump or curve

Mine cuts off my cruise all the time
07-21-2009 05:53 PM
IBHIPRU
Jeep towing problem

HELP! I have a 2009 Jeep Wrangler X that I pull with a Class C Winnebago. On a trip a couple of months ago, I experienced a feeling that the jeep breaks were locking up, especially at the beginning of the trip while going around a curve. It felt like someone was stepping on the break and releasing it a couple of seconds later. It happened once or twice in succession but did not recur for the remainder of the trip. On my most current trip the problem worsened. When leaving Payson. AZ I was going down a hill with a curve and my jeep brakes apparently locked up for about two seconds, then released. The problem didnít repeat the rest of the way to Deming. Upon leaving Deming, the lockup occurred again going around a curve. Leaving Ruidoso, again, a lockup when turning a shallow curve. A few minutes later, going down a hill in a straight trajectory, the brakes locked up again (2-3 seconds) so severely that I drug the jeep for about 10 yards. I pulled over and went through the process of placing the jeep back into TWD and then putting it back in tow mode. The rest of the trip was uneventful. I stopped at a Jeep dealer in Santa Fe, explained the situation and they ( 25 years experience?)had no clue as to what was going on. One other thing that may or may not be related to the problem. When starting the Jeep, momentarily the ESP/BAS indicator comes on along with an icon showing a car skidding (normal). However, in my Jeep, those indicators occasionally pop up while driving, sometimes staying on for several miles before going off. There is also a possibility Iím somehow not setting the Jeep up properly for towing. Here is the sequence I follow which pretty much follows the manual (1) Ignition on ACC (2) Transmission in neutral (3) transfer case to neutral (4) transmission to park (5) emergency break off. My only deviation is I donít start the Jeep to make sure its in neutral (Itís fairly obvious when the shift knob is in the neutral position) and I donít disconnect the negative battery terminal (I need power for when I use the brake buddy). To answer an anticipated question someone might have, I verified the brake freeze up was not the result of a brake buddy malfunction. I also verified that my tow hookups were proper (no binding). Any ideas would be appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 10:26 PM.



Jeepģ, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC