Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ Tech Forum > body mount replacement

Join Wrangler Forum Today

Thread: body mount replacement Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-04-2008 04:26 PM
Howie I had a few of mine go as well. I think its from driving 45mph down bumpy dirt roads, and the body lift beat the mounts until they cracked. I had some steel laying around and drilled and rewelded everything. Havn't had a problem since, but I don't Baha it anymore.

07-04-2008 03:19 PM
former USMC Depends on how many times you want to do this. The frame and body seperate real easily. I would do it right... once and never look back. Anything else is just a waste of time and money.
07-02-2008 12:15 PM
body mounts

I just finished up rebuilding my 94 yj. One of the things I did was replace all the body mounts. I made mine. I used 1/8" steal plate drilled a hole big enough to fit the bolt through and the welded a nut to back side. Then carefully cut out enough of the body to fit the new body mount flush and welded her up. make sure you remove your fuel tank. It cost almost nothing I had most of the steal kicking around and the grade 8 7/16" and 1/2" nuts where cheap. after I was done I painted everything up and it looks good,and extremely strong. While I was at it I did a similar thing with 1/4" inch x 2" flat steal, welded to the frame for the crossmember. stengthen's the hell out of the frame and makes it alot easier to remove the crossmember. My wrangler was a southern jeep that only saw one vermont winter last year,It will never see another vermont as long as I own it. Salt is good on chips, but not on jeep's.
07-01-2008 07:26 PM
body mount replacement

ok so my jeeps 6 of the 8 body mounts r shot (you can see them cracked through the floor) and the front ones r starting to crack through, i found steel plates (front and rear) from Quadratech that can be welded over the old floors. will this suffice or should i save my money and buy a whole new body. its an 88 jeep Sahara. i want to start off roading asap

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 06:47 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC