|06-06-2012 04:15 PM|
Took me 3 bottles and going to save the last for touch ups but here is a after picture of today and hopefully install everything back in tomorrow.
|06-05-2012 07:54 AM|
|GoldenSahara00||I left the bolts in that you pictured. They come right out. You can use the stuff mentioned, or if you have them handy, golf tees work great too. As far as under the seat just spray from different angled. Then use your little bit left at the end on a brush to touch up spots you may have missed.|
|06-05-2012 07:49 AM|
Here I hope this help you
|06-04-2012 12:36 PM|
Also found this under drivers seat. Maybe someone autographed their initials from the factory? Lol
|06-04-2012 12:00 PM|
I used wadded up paper towels at first, but it was really hard to remove in one piece and left some chunks in the liner.
|06-04-2012 11:41 AM|
|McDaniel||when i get home tonight i will try to post up some pictures. Foam ear plugs work great for masking all the bolt holes.|
|06-04-2012 11:34 AM|
|McDaniel||The first pictures shows the mounting plate for the jack & jack handle. The next picture i think is one of the bolts for a heat sheild under the tub and above the exhaust, I would leave those and raptor over them.|
|06-04-2012 08:44 AM|
|Colin||Alright will do thank you for the help!|
|06-03-2012 05:36 PM|
|Futuresweets10||DONT remove anything with rivets like in the first pic. If you want to ever be able to get the bolt out in the second pic Id take it out. You can go over it, cut the liner off later and then patch the liner if you dont want to take it out now. Its all a preference thing.... Do you want it to be easy to remove later and not covered in liner or covered in liner and not easy to remove later. If you do spray over it, id spray it very light.|
|06-03-2012 05:20 PM|
Raptor lining questions
I have started prepping my jeep now for raptor liner and got the bolts out for the passenger seats. But once I removed the seats and the contraption below it I have this piece of metal which I'm unsure of if I should remove? Or if you can't do I just spray as best as I can in the cracks?
Also do I need to remove bolts such as these? I know I need I tape off the bolts in use for seats etc, but the bolts in the picture don't go to anything but below the jeep.
Any help would be appreciated!