|07-21-2012 09:37 AM|
|Mody n Domy||I told you last night that I didnt have any metal particals in my filter after 1321 miles I was wrong I didnt take the filter into the direct sunlight and look at it last night. When I held it in the sun today and separated the folds in the filter there was small metal particles at the bottom of almost each fold. They were small but they were there, makes me glad I changed the oil when I did. The filter did its job so I know the Amsoil and NAPA gold filter will work I have been using this combo for years.|
|07-21-2012 08:42 AM|
While newer engines don't seem to need the break in that engines did years ago, the differentials, especially the rear, need time to break in.
And while the front diff gets airflow to keep it cool, the rear diff will run hotter than normal during break in. The advice in the owners manual applies equally to the diffs.
|07-21-2012 08:18 AM|
|07-21-2012 07:52 AM|
"Drive it like you stole it" and don't look back!!
The old break in procedures from Grandpa's era no longer apply to modern vehicles. Drive it at a variety of speeds and put some stress on that engine.
You also don't need to change oil at 100 miles. Break in oil is no longer used.
|07-21-2012 01:08 AM|
|07-21-2012 12:54 AM|
|aha||Pluke I am with ya man! I was wheeling with mine at 200 miles on the odometer!|
|07-21-2012 12:37 AM|
Probably a dumb question.. I haven't had a brand new car in years.. Do i need to take it to the dealership for oil changes for my warranty to be valid?
|07-20-2012 09:51 PM|
|Mody n Domy||
Just changed oil in my sport at 1321 miles looked at filter and found no metal or
particles at all. I used a NAPA gold filter and Amsoil 5w-30 signature oil. I have used Amsoil in my last 3 cars total miles 350,000 with no oil related problems. And no I don't sell it.
|07-19-2012 02:12 PM|
|07-19-2012 04:04 AM|
|J708||dealership advised to take it easy the first 600 miles|
|07-19-2012 02:07 AM|
|chim-chim7||I did my first oil change at 5k and it was the first vehicle I have even gone over 1k with before its first oil change. There was not even the smallest flake of metal in the element. I see no reason on the Pentastar to change early. On my bikes that have wet clutches they get changed every race day. I also think synthetic is a waste of money but what do I know. I have only been twisting wrenches for 30 years. Everyone has a different opinion, either way you decide will be fine.|
|07-18-2012 08:11 PM|
|doubleuarex2011||Ive never let it go longer for 1k the first oil change. And I change mine after every 2k from there forward. Seems kinda silly but its done well for me, and my WRX sure likes it a lot.|
|07-18-2012 07:18 PM|
^ the jeep gets pretty zippy in high rpm although the engine sounds like its gonna fall apart.
btw, i'm at 750 miles. when do u guys recommend to change oil?
|07-18-2012 06:42 PM|
Jeeps can go 90+? =P
Mine gets to 70 and the top sounds like it's going to break free.
|07-18-2012 05:01 PM|
|07-18-2012 04:50 PM|
|07-18-2012 04:41 PM|
|pluke the 2||
less then 1k miles
if you break it in, break it right.
|07-18-2012 04:38 PM|
Just Run It
I picked my new Freedom Edition the other day. Took it on a 259 mile run to Washington, DC in which I had stop and go driving, 90+ mph on the highway, creeping along at times, etc. Getting ready to change out the initial oil and filter at 600 miles or so.
I've had many new cars and never follow proper new break in procedures and every single one never missed a beat. Broke in the sports cars and cycles by running them hard. Not beating them to death or twisting them up to red line but just good hard running. Again, never a problem. That is starting with a 1980 Mustang Cobra Turbo motor and close to 50 new ones since. Remember those days?
|07-18-2012 01:54 PM|
ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine and
drivetrain (transmission and axle) in your vehicle.
Drive moderately during the first 500 miles (800 km).
After the initial 60 miles (100 km), speeds up to 50 or
55 mph (80 or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration within the
limits of local traffic laws contributes to a good break-in.
Wide-open throttle acceleration in low gear can be detrimental
and should be avoided. Trailer tow is not recommended
during break in period.
The engine oil installed in the engine at the factory is a
high-quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur. For
the recommended viscosity and quality grades, refer to
“Maintenance Procedures” in “Maintaining Your Vehicle”.
NON-DETERGENT OR STRAIGHT MINERAL
OILS MUST NEVER BE USED.
|07-18-2012 01:40 PM|
How long to break in new engine?
Just picked up new Black Wranger Altitude. How long do I have to go to "break in" the engine? I'm at 125 miles right now