Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > Check engine light after body lift!

Join Wrangler Forum Today


Thread: Check engine light after body lift! Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-06-2012 05:24 PM
Border Dave
Quote:
Originally Posted by thedaringmove View Post
How would I go about resetting it?
If you don't have a scanner, I've heard you can:

1. Disconnect the negative battery cable for a few minutes and then reconnect

or

2. Disconnect the negative batter cable and tap the brake pedal to discharge any voltage still in the system and then reconnect

or

3. Disconnect both battery cables and touch them together. Then reconnect.

or

4. If you've already repaired/solved the issue, the CEL will go off after a few cycles of starting the jeep.


For steps 1, 2, or 3, if you haven't solved the problem, the light will almost immediately come back on.
08-06-2012 05:20 PM
Border Dave
Quote:
Originally Posted by UnlimitedLJ04 View Post
code 12, 42 and 65? what are those in OBD terms?
Those are the type of codes the 1997 models use.
08-06-2012 04:45 PM
thedaringmove How would I go about resetting it?
08-06-2012 04:44 PM
thedaringmove 55 came after 65. Thanks
08-06-2012 02:05 PM
RUBI 4 MY MRS Are you sure the last one isn’t 55? That is the code for “Completion of fault code display on the Check Engine Lamp (MIL)”. The * indicates codes stored but shouldn’t set the CEL. Actually none of the codes listed should set the CEL so I’m not sure why the light is on. I would reset the CEL & see if they return.

12* Battery Disconnect Direct battery input to the PCM was disconnected within the last 50 key-on cycles

42* Auto Shutdown Relay Ctrl Circuit; or No ASD Relay Output Voltage at PCM; or Fuel Pump Relay Control Circuit; or Fuel Level Sending Unit Volts Too High (or Too Low); or Fuel Level Unit No Change Over Miles An open or shorted condition detected in the auto shutdown relay circuit; or An open condition detected in the ASD relay output circuit; or An open or shorted condition detected in the fuel pump relay control circuit; or Shorted (or open) circuit between PCM and fuel gauge sending unit; or No movement of fuel level sender detected

65* Power Steering Switch Failure Power steering high pressure seen at high speed (2.5L only)

* = This DTC will not cause the Check Engine Lamp (MIL) to illuminate. However, if another problem causes the MIL to illuminate, and this code is identified when you display all of the codes, at least you will know what it means.

(Not all code references show the * so maybe these will set the CEL in some cases.)
08-06-2012 01:43 PM
UnlimitedLJ04 code 12, 42 and 65? what are those in OBD terms? as in P0420? or P0042? very different things, so please clarify.
08-06-2012 01:28 PM
thedaringmove
Check engine light after body lift!

Just installed the "Zone Offroad" 2" body lift and now my check engine light is on. I got the Codes 12 (expected), 42, and 65. Anyone know anything about these? Thanks!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 03:55 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC