Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > YJ Jeep Wrangler Forum > YJ General Discussion Forum > She broke the block!!!

Join Wrangler Forum Today


Thread: She broke the block!!! Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-27-2008 07:00 PM
redneckcowboy28 Well from what I can figure the engine was severly overheated before we got it. It is the 4.2L with a Holley 600 carb. As for what she was doing she just decided to drive it to town and it go boom. Oh well give me something to do this winter. Now for the big decision on the axle swap. Do i go spring over and go to 35" tires or stay spring under with the 33's?
09-24-2008 01:27 PM
4Jeepn Hm, so what was she doing when the breakage happened? As for fuel injection I think 91 and new is when th 4.0L got it on the YJ's.
09-23-2008 08:16 PM
screwloose how in the world did you..........she.....crack a cast Iron block? So your 89 is a 4.2L? Is it carb'd or injected? I thought 88 and on were fuel injected 4.0 L? The 258 out of the 81 is basically the same block. In 81 i think the manual trans was a T-4 or T-176 and the axles should be the same width (44's would be sweet!)? The wheel base is different so simple measurements should tell you if it fits but you'll likely need different shafts. You can determine the gearing by jacking up the rear end and turning the rear wheel one revolution and counting the number of turns the driveshaft makes by comparison. bout all i have
09-21-2008 12:16 PM
redneckcowboy28
She broke the block!!!

Well the girlfriend broke the block on the jeep! Not really her fault that I can find but i blame her. Block has bout quarter size hole beside motor mount on each side and a crack over the fuel pump. But no fear I have a fix! Awhile back i bought an '81 J-series pickup for cheap. From wat i found the engine is the same, and the truck has d44 axles in it. The pickup also has a 4-speed tranny. I am considering swapping the tranny and tranfer case out of the truck too. The current jeep tranny likes to jump out of reverse and for wat I have heard rumor of the truck tranny and tranfer would have lower gear ratios than the wrangler currently has. Any suggestions will be appreciated and thought thru well since this and the house and couple other projects are on for the winter cold. Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 07:45 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC