Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum > My new to me 99 TJ

Join Wrangler Forum Today

Thread: My new to me 99 TJ Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-23-2012 10:12 PM
Big Cole You will need to also install a set of rear upper adjustable control arms when installing the sye/cv shaft, which are not included with the zone lift. East Coast Gear Supply is a common distributor of 8.8s. I would suggest installing the lift, sye, and 8.8 all at one time then having the cv shaft made for to your specifications. I'm not sure what transmission you have but if its the 5 speed manual then you may want to consider 4.56 gears in the 8.8 and having your front Dana 30 regeared to match. At this point, you might as well install lockers too.
08-23-2012 08:39 PM
kecksnext I would add your SYE the same time you do your lift. Then you can save for your gear swap.

I never owned a jeep with coil overs but i did my 3" budget lift with hand tools and a spring compressor with no issues other than the usual stuck bolt or 3.

* i meant never owned a jeep with leaf springs
08-23-2012 08:27 PM
Rockcop I realize my thought process is out there but give me a little help.
08-23-2012 05:32 PM
My new to me 99 TJ

Finally after having 2 CJ's and 2 YJ's I've crossed over to the dark side. The jeep is spotless as far as rust or dings. I think I got a good deal, but that's always in the eye of the beholder.

Here's where I have a problem. I understood the leaf sprung suspensions pretty well. I'm clueless about coil springs. Based on my research their much more finicky and complicated.

A few questions for you experienced folks. I plan on the following upgrades but I'm not sure what order to do them. Budget is a issue. I can spend money but not all at once.

1. Suspension lift to accommodate 33" tires know with the ability to do slight modifications to fit 35" in the future. I was thinking the 4.25 Zone combo first and adding spring spacers and adjustable control arms over time.

2. SYE and CV shaft: Can I do this first or will my suspension changes require to many DS modifications?

3. 8.8 rear axle and gear change.

Compared to lead springs, how difficult are coil spring suspensions to change and get setup properly?

PS: I know the 3" body lift is bad juju! It will be removed eventually along with
All the tube crap. ;-)

Attachment 153199

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 02:02 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC