|09-30-2012 12:53 PM|
|DILLIGAF||I grabed access to my harness wiring as the wireloom came around the drivers side rear, quarter panel ust before it dives down to the signals, bought the female setup with the led indicators, looks nice and tucks in out of the way when not in use.|
|09-30-2012 11:39 AM|
etrailer.com easy and painless
i just installed one on my 93
|09-30-2012 09:40 AM|
|murphydabe||Thanks for the tip.|
|09-29-2012 09:15 PM|
It won't be likely as there isn't a single point at the rear. The wiring comes back on the driver's side and crosses over to the passenger. The right turn signal wire should be continuous so it doesn't lend to an adapter.
The wiring goes along the top of the driver's rear fender. You can work there and get all 3 of the wires. Then just extend them through the grommet and down through the fender to exit at the rear. Takes a little longer pigtail but works well. And gives you a reasonable place to work and check later.
|09-29-2012 08:55 PM|
Trailer wiring adapter
Anybody know if an plug in adapter is available for an 1988 jeep wrangler? I kinda thought of taking an easier way to wire up trailer connection if possible.
Everywhere I go looking they think I'm crazy.