|11-23-2012 03:34 PM|
|Jerry fain||No I wouldn't see if you can maybe look up with a flash light or something I wouldn't drop the skid untill I got a new Trans mount but if you have to then you have too or u could remove the boot inside the jeep and loo down on top of it|
|11-23-2012 03:31 PM|
Do i have to take off the skid again?
|11-23-2012 03:26 PM|
I now realize this but i dont know how else would you get under wranglers?
|11-23-2012 03:23 PM|
|Jerry fain||Try looking at the linkage under the body (on the transmission) and see if possibly when it sagged down it got hung up on something also you may have a point where the 4wd lever is knocking the body since its attached to the tranny when it sagged it brought the whole lever and all with it nothing major if its on the body where it's hung then you can cut a notch in the body and boom got 4wd back|
|11-23-2012 03:21 PM|
|UnlimitedLJ04||the only thing that holds your entire engine, transmission and t-case drivetrain assembly up is the transmission mount and the motor mounts. By removing the bolts from the t-case skid, you effectively removed the support of the transmission mount and rested the entire assembly on the exhaust hangers and the motor mounts. very bad.|
|11-23-2012 03:19 PM|
|11-23-2012 03:15 PM|
|Jerry fain||Also what aspect of your 4 wheel drive dosent work? 4 high 4 low etc|
|11-23-2012 03:14 PM|
|Jerry fain||Well as far as the skid plate and the tranny go I can't be of much help but the cat with the female flange I may be able to help with when I worked at autozone we had pipe diameter increasing tool you could rent that may help a little unless u went from like a 2 1-4 in. Pipe to like a 3 incher it should help with that. I'm also 19 so I understand the whole parents getting mad thing but I moved out so I dot worry about them much anymore|
|11-23-2012 02:55 PM|
jeep TJ with a few problems
Well for starters I am an nineteen year old kid that may or may not have just messed up his first truck. I wanted it to sound a little ballsy so i put some money into an exhaust system but there was a problem when i took off the skid plate i stripped out one of the middle screws so i just let the plate hang on the transmission(stupid i know but idk what else to do) so as i was getting the old system off i noticed the driveaxle was sagging with the transmission, i freaked out and quickly bolted the skidplate back on and continued to get the exhaust off. i also noticed that the catalytic converter doesnt have a female flange like summit said it did.
i need to know what size the cat out side is to get a converter and my fourwheel drive also doesnt work (i assume its from the hanging) but i need help with some fixes or my dad will kill me!