|10-16-2013 07:26 AM|
|08-13-2013 03:42 PM|
|jkeith00||So... any new updates on this front in the past 9 months? I just ordered up a set of power steps and want to do a manual override for doors off (or non powered half doors).|
|11-28-2012 06:11 PM|
|11-28-2012 05:15 PM|
|kruss||Found more information on the wiring. Looks like I can simply change the DPDT to a SPDT.|
|11-28-2012 04:41 PM|
Amp Research PowerStep Switching
There may be a more appropriate area for this thread. If so, I apologize in advance and kindly ask to be moved to the correct discussion.
I just bought a 2013 Sport that has Amp Research PowerStep running boards installed. They are a great product (for non-extreme crawling) with a really funny drawback when installed on a Wrangler: they close (or go up) when the doors are off. You can get them to stay down by stepping on them while you disconnect the door wiring. But, that's WAY TOO SIMPLE for me. Half the fun of buying my Jeep was so I could make it my own (mods, add-ons, etc).
The bottom line is that I'm hoping there are some electrical switch modding pros who can tell me if I'm on the right track or not with my proposed switching setup:
One DPDT rocker switch that routes between the door ajar wiring (chassis side) and one SPST rocker switch that simulates the door state (open or closed). The DPDT would be located down by the door wiring connector while the SPST would be located on the side of the dash facing outward. The SPST could be easily reached while sitting in order to step out and while entering in order to step up.