Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum > rpms raise when clutch pressed

Join Wrangler Forum Today

Thread: rpms raise when clutch pressed Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-06-2012 09:59 PM
Zjones1994 So tonight after cleaning the throttle, iac, and tps i had a code come up after. Took to auto zone and had 3 codes
Iac circuit condition higher/lower than expected.
Engine cold for too long
Throttle positioning sensor.
The iac one is the only one that has multiple things that could cause it. Im assuming replacing the iac but it also says vacuum leak. How do i check that?
12-06-2012 07:06 AM
gomezaddams I had the same problem in my mustang. After going through everything else replaced the throttle position sensor even though it checked out fine. No problems since. Do clean the iac and mass air flow sensors first though,just to see.
12-06-2012 02:57 AM
03Ruth Try this...
Cleaning IAC and Throttle body write up (for dummies) -
12-06-2012 02:50 AM
Sccafire Check all you vacuum hoses. Make sure they are all hooked up properly and do not have cracks or holes in them.
12-05-2012 09:02 PM
Zjones1994 I just took it for a drive after checking the throttle body and its clean as can be. Air filter is good. As far as i can tell the throttle cable isnt hanging up. I did notice it only happens when im in neutral, or with clutch engaged, and moving. Once i come to a complete stop they drop back down
12-05-2012 08:01 PM
rpms raise when clutch pressed

I just changed my thermostat and long story short my jeep was drivin by my dad for about 5 minutes after it overheated. That's not the problem, now everything is worked out, though i need to change the t-stat again , but now whenever i drive il press the clutch in to shift or come to a stop the rpms go to somewhere around 1500-2000. It only does it after being driven. Idle is at about 750 though it does seem a little rough. Anyone have an idea of whats going on?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 10:17 PM.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC. is not in any way associated with the Chrysler Motors LLC