Jeep Wrangler Forum - Reply to Topic
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > General Jeep Discussion > 4 Inch Lift on TJ now Having Vibration Issues

Join Wrangler Forum Today


Thread: 4 Inch Lift on TJ now Having Vibration Issues Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-31-2013 07:06 PM
jerryj
Quote:
Originally Posted by 02WranglerTJ View Post
I wonder off adjustable upper control arms would do the trick?
Not sure with a 4" lift I would think its pretty far off now but a little adjustment goes a long way.I just finished my 8.8 and didnt get it strait enough at first and had some vibration I have adjustable upper and lowers so with a little adjustment it went right away.
01-31-2013 04:56 PM
Moabite I had a similar problem with a 4-inch Teraflex lift on my TJ, except the vibration was around 50 mph. I installed adjustable upper control arms so that we could fine-tune the pinion angle and that helped. The kit only came with adjustable lower control arms. I installed a Tom Woods driveshaft and the problem was solved. The other problem associated with the lift was front-end wobble. I installed an adjustable track bar and lived happily ever after. It's all part of lifting a jeep...but the lift manufacturers never tell you that.
01-31-2013 04:05 PM
Quest4life I have a 3.5" lift and had vibration issues. Mine are at about 45 to 50 MPH and goes away the instant I let off the gas. I have installed the SYE and a double carden drive shaft. Replaced all u joints in the front drive shaft. I installed both front and rear adjustable track bars. I had all the tires re balanced. I still have it This weekend I am installing rear upper adjustable control arms to get the perfect angle for the pinon. The only thing left to do after that is the front drive shaft angle. I am running out of ideas so if you get an answer please post it.
01-31-2013 03:09 PM
02WranglerTJ I wonder off adjustable upper control arms would do the trick?
01-31-2013 02:31 PM
jerryj ya you need a slip yoke eliminator and drive shaft.I didnt do mine but have seen it done its not bad.Look on you tube you can see just about any thing being done on there.Good luck

If the lift is adjustable you may need to adjust your pinion angle also.
01-31-2013 09:47 AM
02WranglerTJ I was afraid you were going to say that. Did you install it yourself, if so was it difficult?
01-30-2013 04:36 PM
ninjaturtle0 I think vibes are a part of lift's 4 and up... there is a forum on cv drive shaft and sye out there. I had it installed about 6 months ago... no more vibes.
01-29-2013 01:42 PM
02WranglerTJ
4 Inch Lift on TJ now Having Vibration Issues

I recently installed a Rough Country 4 inch lift on my TJ. I am experiencing vibration issues now from 1st to second gear on the lower end of accelerating. It's only noticeable then if I take off full throttle. Under normal acceleration you don't feel it. I replaced the u joint closer to the rear differential. The front doesn't seem to have too much play either. The transfer case drop was installed also, only thing I didn't put in was the 4 wheel drive drop bracket. Tires were recently installed an balanced with used tires. Also didn't have an issue with this till I had a front end alignment.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 08:09 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC