|12-24-2013 05:10 PM|
|mello03||Any update on this? I really wish someone would come out with something for the passengers seat.....|
|12-04-2013 06:54 AM|
|12-03-2013 01:59 PM|
|12-03-2013 12:44 PM|
|12-03-2013 09:30 AM|
|12-03-2013 09:03 AM|
I had the installer who did Katzkins put in W.E.T. Seat heaters in my last jeep. There were back and bottom for both seats. I watched them install them and it wasn't too bad of an install. They were the carbon fiber kind, and they wired them into the fuse block in the factory seat heater spot.
I never had an issue with the OCS system in my last Wrangler.
|12-03-2013 08:45 AM|
|Randolph||I installed a WarmSeats seat heater into a '13 Sport S with cloth seats. I've had it switched on 98% of the time since then - not since Susan Donatio in the seventh grade have my balls been so happy.|
|12-02-2013 11:15 PM|
I'll admit failure.
I ordered the Dorman seat heater ($70 per seat on Amazon). I bench tested it (6.5 amps on high, about 2.0 amps on low) then I pulled the seat out of a '13 JKU sport. (easy with an impact gun, gotta use a Torx for the seat belt).
Put the seat on a workbench and started to pull the cover. Unlike earlier models, this seat is fitted with 3 rods down the length of the seat and the approx. 10" square element wont fit without getting it's center crunched.
So after 10 minutes I decided to put the seat back in and watch Sportscenter. I'll probably put this in my '10 (looks doable).
Someone probably makes an aftermarket element for this seat, I just haven't seen it.
|11-24-2013 08:56 AM|
2) where did you get these switches they are friggin awesome!
|11-21-2013 07:20 PM|
|11-21-2013 04:47 PM|
|rubisteph||My brother got a set from ebay and installed them in his rear seats for the kids.... he put the swithes behind the center console.... looks almost stock and work great.... I'm contemplating doing the same in my 10A....|
|11-21-2013 04:23 PM|
When I installed these I had one vehicle the TJ, and I averaged almost 300 miles a week...of which probably 230 were highway..things have changed a lot now, and the TJ if I am lucky only gets about 100 miles per week unless I go Wheeling. So the last time I had the seat covers off I pulled the heater pads out and most of the wiring...when life gets back to normal, but not so busy that I can take the time to work on the TJ maybe I will trouble shoot the switch and wiring......hope this helps? Good Luck!!!
|11-21-2013 03:55 PM|
|Kiriesh||Does anybody worry about these if they get wet? I have seat covers and was thinking of just slipping them between the seat and the cover but its a jeep so its going to get wet and I'd prefer not to start an electrical fire.|
|11-21-2013 02:58 PM|
|11-21-2013 02:34 PM|
My '14 JKUR DD has heated seats. Some other family members are envious, so I need a plan.
|11-21-2013 01:43 PM|
This is what Santa is bringing me....Amazon.com: Dorman 628-040 Universal Seat Heater Kit: Automotive
Already has the cutouts for the listings and I don't think covering the occupant sensor will be an issue....
|11-21-2013 01:19 PM|
|jp2611||FWIW there are seat heaters for the '14s....but IDK if it is aftermarket...our'14 came from the factory with seat heaters.|
|11-21-2013 01:07 PM|
This is cheaper
ACE Engineering Lava Jacket
|11-21-2013 12:57 PM|
|5JKs||Bump, I want to put a seat heater in driver's side of a 2013 JKU. Anyone done this?|
|09-25-2013 10:29 AM|
|Crewski||Bringing back an old thread.....but were any aftermarket seat heaters developed for '13-'14 seats? I have a '14 and winter is right around the corner.|
|02-05-2013 08:40 AM|
WAS GOING TO START INSTALL OF HEATED SEATS TO 2013 JEEP WRANGLER TODAY. AFTER READING MORE ON FORUM CONTACTED STEVE WHITES MOTOR WHERE I PURCHASED HEATED SEATS. ASKED FOR CLARIFICATION ONCE AGAIN THAT THEY FIT 2013. REPLY WAS "NO" SO I HAVE STOPPED AND ARE RETURNING PART NUMBER 82212697 AS THEY DO NOT FIT 2013. THANKS FOR ALL THE HELP WILL BE WAITING LIKE OTHER 2013 OWNERS FOR NEW KIT
|01-29-2013 01:24 PM|
|Vette man||measured the pads the bottom cushion pad is 12" x 9 1/2" the back is 10" x 9 1/2" if that helps. probably put in next week|
|01-25-2013 03:15 PM|
|underwaterdan||subscribed... let us know|
|01-25-2013 11:04 AM|
|Vette man||when i bought mine it was for 2013 from the dealer I listed in earlier post. I will find out when it warms up and i try it.|
|01-25-2013 12:24 AM|
Thanks for the comments. I saw your post and ran into the same issue. However, Check Corp can't be the only show in town.
I called the local dealer and at first he said yes, there's a kit, then when we looked further, he found a comment that it won't work with the 13's. I think the reason is the seat upholstery changes between 12 and 13. The seat fabric is held down in different locations so the one large panel won't slide in like the MOPAR instructions show.
Here's the front part of the foam bun with the cloth pulled up. You can see the U-shaped recess for the upholstery tie down strip.
Futher back there is a seam that runs along the center of the seat (along your tailbone). This seam is glued down directly to the foam.
|01-24-2013 10:51 PM|
|Vette man||Do more checking here there is a lot written about it. I have a 2013 and bought the Mopar unit with special switches from Check corp. Check corp won't sell you one for passenger seat because of the air bag sensor. I have not installed yet because its been to cold to work in garage. Mopar is available at Steve White Motors. North carolina. $251.94 total shipped|
|01-24-2013 10:46 PM|
Aftermarket Seat Heater for 2013
Has anyone found an aftermarket seat heater kit for the 2013?
The MOPAR kit only works on Wranglers up to 2012 and no MOPAR kit is available for the 2013 yet.
There's information here regarding Check Corp. Their kit has both seat and back for the driver, but only back for the passenger due to a sensor in the seat. I got the same information from them today as well.
I've got a system that I bought several years ago that I'm going to see if I can install it in these seats, but I also would like to know if there's another option.